Parts of a Tree
Finishing
Measurement
Jointer
Drill Press
100
The outer most layer on a tree trunk.
What is the outer bark?
100
When sanding your project, in which direction do you sand?
What is with the grain?
100
How many inches are in a foot?
What is 12?
100
Which part of your board is most often cut on the jointer?
What is the edge?
100
What should always be removed from the drill press after the bit is installed?
What is the chuck key?
200
The thin transparent layer in the trunk.
What is the cambium
200
What does the number on the back of a piece of sand paper represent?
What is particles per square inch?
200
How many feet are in a yard?
What is 3?
200
For our class what is the maximum depth of cut?
What is 1/16th of an inch?
200
What should be placed under your board to prevent the back from breaking out?
What is a scrap piece of wood?
300
The center of the tree trunk.
What is the pith?
300
What liquid changes only the color of your wood when you apply it?
What is stain?
300
What is the formula for Board Feet?
What is (LxWxT)/144?
300
What should you use to push your piece of wood through the jointer if it is shorter than the fence?
What is push stick or block?
300
Large drill bits require what type of speed?
What is a slow speed?
400
The top of the tree.
What is the crown?
400
What is the liquid we spray on our projects to protect them from dust, water, etc.....
What is Polyurethane?
400
What is the formula for calculating the cost of lumber?
What is BDFT x Unit cost?
400
What part of the jointer do you move to have the least amount of cutter head exposed as possible?
What is the fence?
400
Small drill bits require what type of speed?
What is a fast speed?
500
The bottom most part of the tree, found in the ground.
What is the roots?
500
What should you do between your first and second coats of polyurethane?
What is wet sand?
500
How many feet are in 60 inches?
What is 12?
500
Your piece of wood should always be tight against the fence and what?
What is the table?
500
What type of drill bit should only be used in our drill press?
What is straight shanked drill bit?
M
e
n
u