Supply system
Foundation Brakes
Truck/Tractor fundamentals
Truck/Tractor Vavles
More Valves
100

This component supplies pressurized air to the air reservoirs 

What is the Compressor

100

This component takes are pressure and converts it into a mechanical movement 

What is the Brake Chamber 

100

When both the spring brake and service brake are applied simultaneously this is known as 

What is compounding

100

This valve is allows for actuation of both Primary and Secondary air Brakes systems

What is the Dual Circuit Brake Vavle

100

This valve with engage the Spring Brakes as well as engage the trailer spring brakes when trailer is being towed and the valve is pulled out 

What is the Park Control Valve

200

Known as the "brain of the operation" this component of the supply system is in control 

what is the Governer

200

This component must complete three different jobs in order to be fully functional in an air brake system

What is the Slack adjuster 

200

When compressor is in the loaded state, air pressure is not present at this location

What are the unloader valves

200
Whose job it is to both reduce lag and drag time in an air brakes system 
What is the Relay Valve
200

Keeping the Spring Brakes released when traveling down the highway is of utmost importance, this valve ensures this regardless of reservoir air pressure 

What is the Supply double check Valve

300

Typically found on the supply/wet tank controls the maximum system Pressure

What is the Safety valve

300
Air Brakes system fault due to increasing temperature of foundation brake components 

What is Brake fade

300

In order to determine whether or not a compressor is functioning properly, a technician will conduct this test  

What is Compressor Build time

300

Later replaced by a Ratio Valve and then ABS, this valve allowed for quick exhaust of secondary system air 

What is the Quick Release Valve

300

If this Valve remains closed there will be no service signal air traveling backwards to the glad-hands

What is the Tractor Protection Vavle

400
Fully Mechanical or Electrical of these are Located on the Primary and Secondary air reservoirs 

What are air pressure gauges 

400

If GVW of a vehicle is doubled the power required to stop is 

What is doubled 

400

The air drier is equipped with this in order to release moisture and contaminants out of the system 

What is a purge valve 

400

Found in the Primary brake system this valve is responsible for anti-compounding 

What is the Spring Brake Relay Valve

400

Known commonly as the "Spike" this valve pulls from the Secondary system only when not included with a supply double check valve 

What is the Trailer Brake Control Vavle

500

When the compressor is being rotated by the engine geartrain but no longer actively pumping air this is known as 

What is unloaded state 

500

Can be of the welded or bolted type this component supports and transfers braking forces 

What is the spider 

500

Most often found in the air drier and the automatic drain valve 

What is a heater 

500

When the Primary reservoir air supply has been exhausted this valve will allow for mechanical engagement of the spring brake chambers in a body loaded truck

What is the Spring Brake Valve

500

Prior to ABS, this valve allowed modulated foundation braking when a tractor unit was traveling down the road between loads 

What is the Bobtailing Valve (Bobtailing Proportional Relay Valve)

M
e
n
u