Safety Fundamentals
What are Hazard and risk?
Anything that is danger and can cause harm
IATA airport codes are mainly used by Air Traffic Control.
False. ICAO codes are used by ATC.
What does PPE stand for?
Personal Protective Equipment
What does FOD stand for?
Foreign Object Debris
You can operate GSE even if the brakes are defective, provided you drive slowly.
False
True or False: Safety is only the responsibility of supervisors.
False
What does AOG mean?
Aircraft on Ground.
A colleague is rushing to complete a task and skips a required safety check. What should you do?
Stop or intervene appropriately and ensure the required safety procedure is followed.
True or False: Ear protection is required when noise exceeds 85 dB.
True
What does GSE stand for?
Ground Service Equipment
Name 6 steps of Risk Management?
Eliminate, Reduce, Isolate, Control, P.P.E , Monitoring.
What does ICAO stand for?
International Civil Aviation Organization.
Name two tasks that require authorization before performing.
Airside Driving Permit, GSE Certification, Load Control License.
What is an aircraft engine danger area?
An area where engine intake, exhaust or propeller hazards may exist .(Jet blast and Jet suction)
Passengers may travel on baggage tractors without designated seating.
False.
What is the purpose of a Just Culture?
Encourage reporting without fear of punishment
Name the three key main holders at airport operations.
Airline, Airport , and GHA
Yes or No: Can you use unserviceable equipment if the job is urgent or send flight on time?
No
Yes or No: If you become lost on the maneuvering area, should you continue driving until you find your location?
No. Stop and contact ATC.
What is the speed limit inside ERA and what is that speed also called as?
5 km/hr and Walking speed
Safety is the state in which _____ of harm to a person and property is reduced or maintained to acceptable level.
Risk
That is the IATA Code for Ras Al Khaimah Airport ?
RKT
What is ERA?
Scenario: Name three common hazards found on the airside.
A: Aircraft movement, GSE movement, F.O.D, fuel spills, noise, slips/trips/falls, weather, etc.
What should you do if GSE makes contact with an aircraft?
Stop operations, secure the area, report the incident immediately, and follow company procedures.