BRAKES
The heart of the anti-lock brake system
Electronic controller
Excessive tire wear on both tread shoulders is probably caused by
under inflation
Timing belt service intervals are critical on many engines because
Valve damage may occur if the belt fails
Before testing a charging system, the battery
Must be fully charged
CKP sensor
Crankshaft position sensor
This component would be the most likely problem if all four wheels slowly locked up while driving
master cylinder
Bleeding a power steering system is accomplished by
Turning the steering wheel
An engine emits blue smoke for a few seconds when starting cold. Why?
Worn valve seals
The most common wire identification on wiring diagrams is this type of coding
color
ECT
Engine coolant temperature
The number 10.090 cast into the brake drum refers to the
discard diameter
Where on the tire can a radial tire puncture be repaired
In the tread area.
The correct order of strokes of a four stroke cycle engine
Intake, compression, power, exhaust
If three lamps of 2, 6, and 10 ohms respectively are connected in a series, their total resistance is
18 ohms
MAF
Mass Air Flow
This is used to measure lateral runout
dial indicator
Is it ever OK to mix tire sizes on a vehicle
No
When replacing cylinder head gaskets, these type of head bolts should always be replaced
Torque to yield
Current is measured in
amperage
MAP
Manifold Absolute Pressure
When replacing the left front caliper on a diagonally split brake system, the correct bleeding sequence is
right rear, left front
The average automotive power steering hydraulic pump has a maximum output pressure of
700-1000
A plastigage is used to determine this
main and rod bearing clearance
The automotive alternator diodes are used to convert
AC to DC
ECM
Engine Control Module