What is the main function of the braking system?
To slow down or stop the vehicle.
What tool do you use to remove wheel nuts?
A wheel wrench.
What should you do before inspecting the brakes?
Park the vehicle safely and secure it.
What happens when brake pads are worn?
Braking performance decreases.
Why are brakes important for road safety?
They help prevent accidents.
What is the function of a brake disc?
It rotates with the wheel and provides a surface for the brake pads to clamp onto.
What tool do you use to measure brake disc thickness?
A micrometer.
What should you inspect on a brake disc?
Its thickness, surface condition and damage.
What can cause squeaking noises when braking?
Worn brake pads or other brake component problems.
What should you do before raising a vehicle?
Park on level ground and use suitable lifting equipment.
What is the function of a brake caliper?
It holds the brake pads and pushes them against the disc.
What tool do you use to measure brake pad thickness?
A brake pad measuring tool or vernier caliper.
Why should you inspect both inner and outer brake pads?
Because they can wear unevenly.
What does brake fluid do?
It transfers hydraulic pressure through the braking system.
Why must you never work under a vehicle supported only by a jack?
The vehicle could fall and cause serious injuries.
What is the difference between a brake disc and a brake drum?
A disc brake uses pads that clamp a rotating disc; a drum brake uses shoes that press against the inside of a rotating drum.
What is a brake fluid tester used for?
To check the moisture content or condition of brake fluid, depending on the tester.
Why must you compare brake disc thickness with the manufacturer's minimum specification?
To make sure the disc is safe to use.
What can cause a vehicle to pull to one side when braking?
Uneven braking force, a sticking caliper or other brake faults.
Why should you avoid touching brake discs immediately after driving?
They can be extremely hot.
What is brake fade?
A temporary reduction in braking performance due to excessive heat.
What tool can you use to check brake disc runout?
A dial indicator.
Describe the main steps in a visual brake inspection.
Inspect pads, discs, calipers, hoses, pipes and fluid level; measure components and compare them with manufacturer specifications.
A customer reports vibrations when braking. What components should you inspect?
Brake discs, pads, wheel condition and suspension components.
Why should you never reuse a damaged brake hose or install components outside manufacturer specifications?
Because brake failure can cause serious accidents.