Valves
Which valve is installed on a front disk/rear drum system, that allows rear brakes to engage before the front brakes?
A Metering Valve
What is the name for a Stop Lamp Switch that controls the stop lamps in addition to cruise control and torque converter function?
A Multi-Function Switch
What condition outside of a leak, can cause a low fluid level?
Low Brake Pads
What is the sign of an overheated tapered roller bearing?
Blue discoloration
If the amber ABS light comes on, does the vehicle lose base braking?
No, it only loses ABS function
How many types of Pressure Differential Valves are there?
3
What measurement is the steering angle sensor taken in?
Degrees
What base brake system defect can cause a false ABS concern?
Warped Rotors
What must be done after replacing a tapered roller bearing?
Set preload and measure endplay
If the parking brake light stays on with the parking brake disengaged, what would I check first?
Parking brake linkage
What type of valve changes pressure based on vehicle weight?
Load Sensing Proportioning Valve
What types of brake fluid level switches are there?
Pole Type, Reed/Float Type
Is the parking brake a part of the base brake system?
No, it is mechanical
What can happen if a sealed bearing is not pressed in straight?
It can damage the knuckle bore and the bearing itself
What is the difference between and amber light and red light in vehicles?
Amber is a needs to be checked, red means immediate concern.
What is the nature state of an Isolation Valve?
Open
If I have a cracked tone ring, what sensor will be effected?
Wheel Speed Sensor
What are the 2 main hydraulic circuit types?
Split Front Rear and Diagonally Split
Which wheel bearings can be serviced and which cannot?
Tapered roller can, sealed cannot
During a traction control event, the light blinks. Is this a normal condition? What if the light stays on?
Yes, if the light stays on though there is a fault
Metering, Proportioning, Pressure Differential.
What sensor controls a light, that comes on when brake pads are low?
Brake Wear Sensor
What should be checked for during an initial test drive of a vehicle in for a brake concern?
Pedal Travel, pedal feel, abnormal noise, vibrations in the pedal or steering wheel.
What is the primary concern with a failed wheel bearing?
If my rear stop lights don't come on but the CHMSL illuminates, what should I check first?
The Brake Switch