Driving Drills
The part of the drill that holds the cutting tool/bit is called the?
CHUCK
Sharper tools ____________ than duller tools.
are safer
A specialized router used to trim the edge of plastic laminate is a:
Laminate trimmer.
The most widely used portable power tool of the carpenter is the:
Circular Saw
The tool which some provincial codes require the operator to be certified because of the potential danger is the ________.
Pneumatic nailer
or
powder actuated driver
Powder actuated driver
The tool that is best suited for drilling through metal, as well as wood, is the?
a) auger bit
b) high speed twist drill bit
c) expansion bit
d) spade bit
b) High speed twist drill
An angle cut on the edge or end of a board that extends from one face of the board to the other is called a _________ cut.
BEVEL
Caution must be used when operating a router because the bit is:
Unguarded
When you make a cut with a circular saw, the waste must fall clear or else the saw blade will ________.
will stop turning
or
bind
Bind
If a powder actuated tool does not fire, it should be held against the work surface for?
10 seconds
or
30 seconds
30 seconds
Masonry bits are most efficiently used what type of drill?
Pistol grip or Hammer drills?
Hammer drills
A cut made on a board with both a mitre and bevel at the same time is called a?
Compound angle/mitre cut
Recesses cut into wood to receive hinges are known as___________.
gains
Which portable saw has the motor positioned behind the blade?
a) direct drive
b) worm gear drive
c) belt drive
b) Worm gear drive saw
When using a powder actuated driver, fasteners should be driven into concrete at least _______ inches from any edge.
a) 1/2
b) 1
c) 2
d) 3
d) 3
To avoid personal injury while using a powerful drill,
a) do not pull the bit from the hole until it is completely through the material
b) never let up on the trigger
c) push on the drill as hard as you can
d) be ready to release the trigger at any time.
D
The saw arbor bolt that holds circular saw blades in position are loosened by rotating the bolt _______ .
With the rotation of the blade.
Stopping the movement of the router while in use will cause:
The bit to burn the wood
The guard of a circular saw should never be:
Wedged open
Which colour of powder actuated driver is the strongest in the list below?
a) grey
b) red
c) green
d) yellow
b) red
Light-duty drills usually have what type of handle?
Pistol Grip Handle
The most common circular saw in use today uses a ______ diameter blade.
7 1/4"
A router accessory used to cut recesses for hinges is a ____.
Template
To avoid splintering along a cut on the finish side of the material with a circular saw, __________.
Make a cut from the back side of the stock.
When selecting a powder charge for a powder actuated gun always use
The weakest one that will do the job.