Construction Basics
Roofing
Tools of the Trade
Remodeling & Interior Construction
Plumbing & Electrical
100

What tool is used to check whether something is level?

A level

100

What is the most common type of residential roofing material in America?

Asphalt shingles

100

What tool is used to drive nails into wood quickly?

Nail gun

100

What is the process of applying joint compound to drywall seams called?

Taping and finishing

100

What does GFCI stand for?

Ground-Fault Circuit Interrupter

200

What does PSI stand for?

Pounds per Square Inch

200

What is the material installed beneath shingles to provide an additional layer of protection?

Roofing underlayment

200

What tool is used to cut wood at precise angles?

Miter saw

200

What material is commonly installed behind certain tile installations in wet areas?

A suitable tile backer board or approved waterproofing system.

200

What is the main purpose of a P-trap under a sink?

To hold water that prevents sewer gases from entering the home.

300

What is the standard thickness of residential drywall commonly used on walls?

1/2 Inch

300

What is flashing used for on a roof?

To prevent water intrusion around roof penetrations and transitions.

300

What tool is used to find studs behind drywall?

Stud finder

300

What is grout used for?

Filling the joints between tiles.

300

What does a circuit breaker do?

Interrupts electrical power when a circuit experiences an overload or short circuit.

400

What is the triangular framework that supports a roof called?

A roof truss

400

What does roof pitch describe?

The steepness or slope of a roof.

400

What is a chalk line used for?

Marking straight reference lines over long distances.

400

What does "square footage" measure?

The area of a surface, calculated by multiplying length by width.

400

What is the difference between a supply line and a drain line?

A supply line brings water into a fixture; a drain line carries wastewater away.

500

What is the difference between a load-bearing wall and a non-load-bearing wall?

A load-bearing wall supports structural weight; a non-load-bearing wall does not.

500

What is the difference between roof decking and roof underlayment?

Decking is the structural surface attached to the roof framing; underlayment is the protective layer installed over the decking.

500

What is the difference between a circular saw and a miter saw?

A circular saw is handheld and versatile; a miter saw is stationary and designed for accurate crosscuts and angled cuts.

500

What is the purpose of a vapor retarder in certain wall assemblies?

To control water vapor movement through the building assembly and reduce condensation risk.

500

What is the purpose of a plumbing vent stack?

To allow air into the drainage system and help maintain proper drainage and trap seals.

M
e
n
u