General Requirements
Lockout/Maintenance
Portable Power
&
Hand Tools
&
Hand Tools
Types of Tools
Safety
100
Any defects found in tools or machinery should be reported immediately to this person.
What is A Supervisor?
100
This person should remove a lockout device when maintenance is complete.
Who is the person who applied the lock?
100
These items should always be inspected before using a power tool.
What is the power cord, plug, and safety guards?
100
The Name of this tool is
What is an Infrared Thermometer?
100
This procedure helps prevent machines from starting unexpectedly during maintenance?
What is Lockout/Tagout (LOTO)
200
These devices are required on machine tools and equipment to help protect workers from injury
What are Safety Guarding Devices?
200
This should be done after a machine is locked out to verify it is safe to work on.
What is test the isolation of energy?
200
This equipment should be worn by employees when operating most portable power tools.
What is protective eyewear equipment?
200
This Type of Brush is
What is Brass Brush?
200
This injury can result from contact with molten plastic, hot barrels, or nozzles?
What are Burns?
300
These should never be used if they are damaged or defective?
What is Tools, machinery, or equipment?
300
This should never be relied upon as the sole means of protecting workers during maintenance.
What is the Start/Stop Button?
300
This part of the tool should always face away from the body when in use.
What is a Saw/Cutting Blade?
300
This portable power tool is commonly used to remove and install mold bolts.
What is an Impact Wrench?
300
This device helps protect users from electrical shock when using portable power tools.
What is A Ground Fault Circuit Interrupter (GFCI)?
400
These hazards should be removed from machine surfaces and work areas to prevent slips and equipment damage.
What is Oil/Grease?
400
This hidden hazard may remain after equipment is turned off and locked out?
What is stored energy?
400
This should be checked before plugging in a portable power tool.
What is the Power On/Off Switch?
400
The name of this tool is.
What is an angle grinder?
400
This type of Injury can occur in seconds and often results in fatal injuries because the worker has little or no time to react?
What are Entanglement Injuries?
500
Oily Rags and Cotton Waste must always be placed in an enclosed metal container separate from other waste to prevent this type of reaction.
What is Spontaneous Combustion?
500
This safety violation occurs when someone bypasses a lock or tag to start equipment?
What is unauthorized energization of equipment?
500
This action should be taken if a power tool sparks excessively.
What is cease work and report to a manager immediately?
500
This device is used to align a mold safely during installation.
What is A lifting eye bolt or guide pins?
500
This dangerous event can occur when a saw blade binds in the material.
What is Kickback?