Towers "R" Us
This is the direction of the sweep if looking down from the top in the cooling section.
What is clockwise?
This is the number of bushels entered into AccDry for garner volume for a 24' level auger hopper.
What is 24?
This is the width of the column of a Delta series dryer.
What is 32"
This is the purge time and trial for ignition for a Fireye control.
What is 12 sec purge and 10 sec trial for ignition?
This is the approximate resistance value in ohms for an RTD in a 190 deg F plenum?
What is 133.861 ohms?
The is the direction of rotation of a 10' or 12' fan looking up from the cooling section.
What is counterclockwise?
This is the direction the discharge auger pulley spins on a Legacy dryer.
This is the horsepower of the top fan of an F660X Fusion dryer.
What is 10 hp?
This is the factory initial valve opening for the Siemens actuator.
What is 20%
This is where a jumper would be installed to bypass the air pressure on burner 1 on a 975 dryer to test the burner.
What is 52 & 57?
This is the size of the screen perforation for a 10' tower in inches.
What is .094"?
This is the thickness of the grain column on an ECO dryer.
What is 14"
This the fill height of a Delta series D900h with a gravity fill hopper within 2'.
What is 32'-10"?
This is the process to enable a moisture sensor on Pinnacle 20/20.
Go to Troubleshooting, press the service button, enter the password (2020) press ok, press service again, check the box next to the appropriate sensor.
This is the size of the drill bits needed to drill out a Maxon burner.
What is 5/64" and 3/32"?
This is the number of floor pieces to complete the grain floor in a 10' tower.
What is 8?
This is the bushels per revolution of the metering rolls of an E600.
What is 3.67 bu/rev?
This is the horsepower of the upper fans on a D1800h Delta series dryer.
What is 40 hp?
This is the screen that displays the McTrax status, software versions and the time and date.
What is System Config?
This is the original founder of Mathews Company.
Who is BC Mathews?
This is the fill height within 2' of a 101375.
What is 64'-7"?
These are all of the components in the safety circuit for a 2020 profile dryer.
What is the customer interlock, E Stops, Motor Overloads and High Limits. If Canadian gas pressue is added?
This is the fan horsepower of the second fan of a Fusion Series F480X.
What is 10Hp?
These are the slopes for the infeed and discharge moisture sensors in the AccuDry settings.
What is 4.5 & 5?
This is the input terminal and the output terminal of the Pinnacle Lite MCR board.
What is 33 & 24?