The releasing of the firing pin detonates the primer.
What is Firing
100
What is the SMR code of the MK19 MOD 3?
What is PAFDA
100
What type of operation does the MK19 use.
What is blowback.
100
What is the corrective action for a runaway gun.
What is lower one or both charger handles
100
What must be done to repair a bent vertical cam.
What is replace the vertical cam assembly.
200
When the operator presses the trigger after charging the gun, the bolt slams forward under spring pressure.
What is Extracting.
200
What does a source code of XD indicate.
What is Item is not stocked. The item must be obtained by local purchase.
200
What assembly consists of the receiver sear and safety mech components inside a sear housing. HINT: the guns safety is mounted on the rear of this assembly.
What is the sear assembly.
200
How many safety mechanisms are on the MK19
2
200
What is the difference between the RH and LH Cam followers.
What is the RH has a double roller whereas the left has one roller.
300
The process of manually pulling the bolt to the rear.
What is charging.
300
what is the SMR code of the feed throat plunger.
What is PAFZZ
300
What does UGWS stand for?
What is Up Gunned Weapons Station
300
Which extractor has a lump on it?
What is the left one.
300
What tool is used to unscrew the bolt sleeves?
What is 1-4/4 inch open end wrench.
400
When loading the gun how many times must the operator charge the weapon to get a round into the firing position?
What is 2.
400
What does a "Z" in the in the third position of the SMR code indicate?
What is the item is not authorized to be removed, replaced, or used at any maintenance level.
400
Point to the striker plate on your weapon
NO
400
How much wood would a woodchuck chuck if a wood chuck could chuck wood?
google it
400
What is the arming distance of the M430 round
What is 18-30 meters.
500
What part holds the firing pin rearward during cocking?
What is the firing pin sear.
500
Which letter. in the SMR code show who can install, replace, or use the item?
What is the 3rd letter
500
what tool is used to make adjustments to the feed slide
What is the feed slide adjustment tool
500
what is used to remove burs from the vertical cam assembly
What is crocus cloth
500
Can you re-link ammunition that has been cycled through the weapon.