This tool ratchets for a straight cut
What is a PVC cutter
This bit is to drill holes in brick or block.
What is a masonry bit?
This fitting will change direction of pipe at a Right Angle.
What is a 90 degree elbow?
This pipe is for water lines that are sweated.
What is Copper Pipe?
These 2 things are needed to join PVC pipe and fittings.
What is Primer and Cement?
Pipe slope can be checked with this tool.
What is a torpedo level?
This tool vibrates and uses different blades. It can be used to trim drywall.
What is an Oscillating Multi-Tool?
This fitting has a branch perpendicular with the run.
What is a Tee?
This pipe is the most flexible and can be bent into an angle without the use of a fitting.
What is PEX Pipe?
This joint method results in a tapered end.
What is threaded?
This tool removes the sharp edge from inside pipe.
What is a deburring tool?
This tool "stretches" PEX A for a fitting.
What is a PEX Expander?
This fitting will change direction of pipe 1/8 of a circle.
What is a 45 degree elbow.
This pipe is for cold water lines only.
What is PVC Pipe?
This joint uses heat, and you will need these 2 things to complete this joint.
What is Flux and Solder?
This tool will clamp copper rings to seal a joint
What is a PEX crimper?
This tool is used to drill through studs in tight spaces.
What is a Right Angle Drill?
This fitting is for joining pipe in a straight line.
What is a Coupling?
This pipe is threaded and screwed together for water lines.
What is Galvanized Steel?
This joint requires a copper ring to seal it.
What is a PEX Crimp?
This tool is used to check a crimp joint for quality
What is a PEX feeler gauge?
This bit is for drilling large holes with a pilot bit, and saw teeth.
What is a hole saw?
This fitting has threads on the outside and will adapt from one material to another.
What is a Male Adapter?
This pipe is rated at 200 degrees and is suitable for use with hot or cold water.
(Chlorinated Polyvinyl Chloride)
What is CPVC Pipe?
This cleans pipe and fittings prior to applying cement.
What is Primer?