GRAB BAG
Before operating any equipment, what should you do
What is inspect your equipment
Employers are required to have fall protection in construction industry at ________ feet above a lower level,
What is 6 feet
An unexpected event in the workplace that had the potential to cause injury, illness, or property damage but did not.
What is a Near Miss
Which United States federal research agency that tests and certifies respirators.
What is NIOSH. National Institute for Occupational Safety and Health.
If a forklift has an attachment to be used on or attached to the lifting forks, where can the attachment weight limits be found.
What is on the DATA PLATE
A barrier erected on a roof to warn workers that they are approaching an unprotected roof side or edge
What is a Warning Line System
What is the first thing you should do before putting on your safety harness
What is inspect your harness
These people have the right and responsibility to stop work if they believe a hazard exists
Who are All Employees?
What does the P in a P100 Respirator stand for?
What is Oil-Proof
Operators must be re-evaluated every ____________ or sooner if they are involved in an accident, near-miss, observe unsafe operation, or are assigned to a new type of truck.
What is Three yearss. 1910.178(l)(4)(iii)
What are OSHA Fatal Four in Construction, taught in all 10 and 30 hour courses.
What is falls, struck by, caught in between, and electrocution
What is 5,000 pounds
These are the Hierarchy of Controls, also known as the Safety Pyramid
What are Elimination, Substitution, Engineering, Administration, and PPE?
This type of positive pressure respirator can be used by someone that has a lot of facial hair i.e. a beard.
What is a Powered Air-Purifying Respirator (PAPR)
When a load on the forks blocks the driver's view, the driver should..... do what?
What is drive in reverse or with load trailing.1910.178(n)(4)
What is the term used for if a person is suspended to long in a personal fall arrest harness
What is Suspension Trauma
What is the difference between fall restraint and fall arrest system
The last step in the LOCKOUT procedure is ____________.
What is Test or Verify that Lockout is effective.
All employees using a tight-fitting facepiece respirator must pass an appropriate fit test. The two methods are ______________________________
What are qualitative fit test (QLFT)and quantitative fit test (QNFT).
When traveling on an incline greater than 10 percent, the load is always carried _______________.
What is upgrade or uphill. When ascending or descending grades in excess of 10 percent, loaded trucks shall be driven with the load upgrade. 1910.178(n)(7)(i)
a protective device designed to protect workers from harmful airborne hazards, including dust, mists, fumes, chemical vapors, gases, and biological agents
What is a respirator
A work area in which certain types of work may take place without using conventional fall protection systems.
What is a Controlled Access Zone 29 CFR 1926.502(g)
is a formal, written authorization and safety checklist used to control operations that produce flames, heat, or sparks—such as welding, cutting, grinding, brazing, soldering, or torch-applied roofing
What is a Hot Work Permit system.
For Non-IDLH environments, employers must use the ___________________ listed in Table 1 to select a respirator that meets or exceeds the required level of employee protection.
What is the Assigned Protection Factors (APF)
_________ is when the operator is 25 ft. or more away from the vehicle which remains in his view, or whenever the operator leaves the vehicle and it is not in his view.
What is The Powered Industrial Truck is unattended.