Mesure it up
This tool is used to measure length, width, or height and is commonly found in toolboxes.
Tape Measure
This power saw is used to make angled cuts, often for trim and molding.
Miter Saw
This part of a cutting torch is where the flame comes out to heat and cut metal.
Cutting Torch Tip
This tool is used in fencing work to pull, cut, and twist wire.
Fenching pliers
this tool uses leverage to pry apart materials, remove nails, and assist in demolition work
crow bar
his measuring tool is used to find the outside width or thickness of an object.
Outside caliper
This saw has a narrow blade held under tension in a metal frame and is used for cutting pipes or rods.
This clamp is attached to the workpiece to safely carry electricity back to the welder.
Welding Ground Clamp
this tool has strong jaws and cutting edges designed for twisting, bending, and cutting electrical wire.
Linemans pliers
this curved part of a hammer is designed to grip and remove nails using leverage
nail claw
This measuring tool is more precise than a ruler or caliper and is commonly used in machining.
Micrometer
Carpenters use this tool to hold material in place while cutting precise angles for trim or molding.
Miter box
This safety device prevents gas from flowing at dangerous pressure levels from a cylinder.
Tank Regulators
This type of pliers is commonly used to bend, hold, or position small wires in hard-to-reach areas.
long nose (Neddle-Nose pliers)
This hammer, with a rounded end opposite the flat face
Ball peen hammer
This tool combines the functions of inside and outside calipers with a built-in dial indicator for easy reading.
Dial caliper
Because of its thin blade, this saw can turn easily while cutting inside a surface.
Keyhole saw
This PPE is essential for shielding hands from high temperatures, UV light, and molten metal splatter.
Welding Gloves
This tool is commonly used for gripping, bending, and holding objects of varying thickness.
Slip Joint Pliers
this hammer features a linear, non-curved claw optimized for increased leverage in dismantling tasks and extracting embedded fasteners
straight claw hammer
Unlike calipers, this tool does not give a direct reading and must be used with another measuring tool.
Telescoping guage
his saw is often started by stabbing its sharp tip directly into the wall surface before cutting.
Dry wall saw
his torch allows a welder to manually control filler metal while maintaining a precise arc with a tungsten electrode.
GTAW torch
This tool is used to deform a metal sleeve or connector so it holds a wire securely without soldering.
Wire Crimping pliers
this non-marring striking tool, typically made with a resilient elastomer head, is used to apply force without damaging surfaces
rubber mallet