DEVICES STANDARDS
TEMPORARY SIGNS
MESSAGE and ARROW BOARDS
CHANNELIZING DEVICES
SPECIAL EQUIPMENT
100

This crashworthiness standard applied to most TTC devices.

What is MASH 2016?

100

Temporary signs are generally placed on this side of the roadway.

What is the right side?

100

The number of displays a typical PCMS message cycle may include.

What is Two displays, normally two seconds each?

100

The minimum cone height for daytime use.

What is at least 18 inches?

100

This certified person controls an AFAD from a nearby location.

Who is a certified flagger?

200

What to do with an unacceptable traffic control device.

What is remove and replace it?

200

The bottom of a portable sign must be at least _____ ft above the traveled roadway.

What is one foot?

200

The mounting height of an operating PCMS board.

What is seven feet above the roadway?

200

The channelizing device that is preferred for highest visibility.

What is Drums?

200

True or false: An AFAD can be a substitute for a continuously operating temporary signal.

What is false?

300

The three categories of traffic signs.

What are regulatory, warning, and guide?

300

This may ballast a portable sign support.

What are sandbags?

300

Where the PCMS board is placed when a protective feature is available.

What is on the shoulder?

300

The reason channelizing devices yield or break away when hit.

What is To keep fragments from entering a vehicle or becoming hazards?

300

The "RUMBLE STRIPS" (w23-7) sign is placed _____ ft in advance of portable rumble strips.

What is 50 feet?

400

Regulatory signs provide _______ legal requirements.

What is enforceable?

400

The top of a sign’s sandbag may sit no higher than ______ in above the roadway.

What is four inches?

400

These arrow-board modes should not be used.

What is Flashing bar and double-diamond modes?

400

The number of devices required in a one-lane two-way taper.

What is six devices?

400

The conditions that protective vehicles are especially important in.

What is on high-speed roadways and when workers are on foot or in lift-bucket operations?

500

Warning signs perform this function for road users.

How we warn road users in advance of roadway conditions?

500

These signs may repeat if the preferred warning sign is unavailable or inappropriate.

What is The Flagger Symbol or Be Prepared to Stop sign?

500

Where an arrow board is placed for a multilane lane closure.

What is on the shoulder at the beginning of the taper?

500

The maximum device spacing at 50 mph in a one-lane two-way taper and tangent.

What is 20 feet in the taper and 40 feet in the tangent?

500

The fall-protection rule that applies while riding in the back of a moving attenuator vehicle during setup.

What is wear a harness and remain properly tethered?

M
e
n
u