Parts of a Drawing
This contains information used to identify the project or any part of the project
Title Block
____ _____ shows the location of a structure on a piece of property and usually shows where water and sewer mains are installed.
Plot Plans
This drawing is a section of piping that is to be fabricated before erection.
Spool Drawings
The outside perimeter of a project
Battery Limits
These are used on Drawings to show information in a small area.
Symbols and Abbreviations
This is a detailed schematic drawing that shows the equipment, pipelines, and control instruments needed to run a manufacturing plant or chemical process.
Piping and Instrumentation Diagram (P&ID)
This is a precise drawing that shows the exact dimensions, shape, and construction details of a specific piece of machinery, like a tank, pump, or heat exchanger.
Equipment Drawings
A piping segment of a pipe system or an ISO
Spool
Usually in the title block, this shows the size of the drawing compared to the actual size of the object represented.
Scales
An __-_____ drawing is a revised set of construction documents submitted at the completion of a project that records how a building or structure was actually constructed, rather than how it was originally designed.
As-Built
This is a drawing that shows the dimensions, materials, and installation steps to build the brackets and hangers holding up a pipeline.
Support Drawings
A group of abbreviations that specify size, service, material, insulation thickness of a given piping segment.
Line Number
These are provided in addition to drawings to explain items that cannot easily be drawn.
NOTES
An _________ drawing is a flat, two-dimensional (2D) drawing that shows a side, front, or back view of a building or interior wall as if you are looking at it straight on
Elevation
This is a 3D view of a piping system drawn on a 2D page. Unlike a flat blueprint, it shows the pipe's length, width, and depth all at once, slanted at a 30-degree angle.
Isometric Drawing
A drawing with detailed plans of a part or system.
Blueprint
________ ______ are usually located in the lower center of the drawing and is used to record any changes to the drawing.
Revision Blocks
These Drawings indicate how the framework of the building is to be constructed.
Structural
This drawing contains separate views, each view shows the shape of the object seen from a different direction or point of view.
Orthographic Drawing
A group of numbers used to indicate a point, line, or plane from the benchmark.
Coordinate