Luminaires & Lighting
1 points
Paddle fans over _____ must be supported independently of the box:
what is 70 lbs
A branch circuit for an appliance that’s a continuous load must be rated not less than _____ of the marked ampere ratings of the appliance:
which is 125%
Receptacles not supplying loads directly related to circulation systems must be located not less than _____ from the inside walls of the pool:
what is 6ft
Flexible Metal Conduit (FMC) must be secured within _____ of each box, cabinet, conduit body or other termination:
what is 12in
The portion of the grounding electrode conductor that is the sole connection to one or more ground rod is not required to be larger than _____:
what is 6 awg
The minimum lighting load for industrial commercial buildings is _____ volt amperes per square foot:
what is 2.2 or 2
The conductors between the service equipment, a separately derived system, or other power supply and the final branch circuit overcurrent device:
What is a feeder
Receptacles located more than _____ above the floor are not required to be tamper resistant:
which is 5.5 ft
The maximum approval electrical trade size of IMC is ________ :
which is 4 in
If multiple power sources supply portable structures, the circuit equipment grounding conductors at each portable structures must be bonded together for all portable structures separated by less than ____:
what is 12ft
A vertically mounted luminaire weighting no more than ______ can be supported to a device box or plaster ring secured to a device box:
which is 6 lbs
An electric heater having a capacity of _____ gallons or less is considered as continuous load for the purpose of sizing branch circuits:
what is 120 gal
Receptacles located more than ______ from the wall or room divider may not be counted as required receptacles:
what is 18 in
RMC is not required to be securely fastened within _____ of the service head for an above the floor termination of a mast:
Separately derived systems rated ______ or less are not required to be grounded:
what is 1 KVA
A luminaire supported by a single conduit shall not exceed ______ in any horizontal direction from the point of conduit entry:
what is 12 in
Branch circuit conductors for information technology equipment must have an ampacity not less than _____ of the total load connected:
what is 125%
Single receptacles that provide shore power for boats must be rated not less than ____:
what is 30 A
In building over 3 floors. ENT must be concealed behind floors, walls, or ceiling that have a _____ minute finish rating:
which is 15 mins
The supplemental electrode for a rod electrode must be installed not less than _____ from the rod electrode:
What is 6ft
Conductors within ______ of ballast, LED driver, power supply or transformer must have an insulation temperature rating not lower than 90oC
which is 3 in
The branch circuit VA load for heavy duty lampholders must be calculated at a minimum of ______ :
what is 600 VA
All _____ 125V receptacles installed in locker rooms with associated showering facilities must be GFCI protected:
what is 15 and 20 A
LFNC must be securely fastened within an interval not exceeding _______:
what is 3 ft
Insulated equipment grounding conductors _____ and larger can be permanently reidentified at the time of installation at every point where the conductor is accessible:
what is 4 AWG