G-Codes
G00
Rapid Traverse
How is a Lathe Sized
Swing and Capacity
What type of collet is used in a Bridgeport ?
R8
What is the most common tool inserted into the drill press spindle
Drill Chuck
What should the upper guard be adjusted to on a Pedestal Grinder ?
1/8"
G42
Cutter Compensation Right
Headstock Function
To rotate the workpiece
Can the RPM be adjusted while running ?
Yes, Has to be running
What type of taper is machined into the drill press spindle
Morse
What should the lower guard be adjusted to on a Pedestal Grinder ? And why ?
1/16"
So your workpiece and/or fingers do NOT get pulled down into the wheel
G17
X Y Plane
What is the Drive Shaft used for
Power Feeding
What does DRO stand for?
Digital Readout
What is the name of the tool that knocks out a tool from the spindle ?
Drift Key
What is the margin of safety for the Vertical Band saw
3"
G91
Incramental Programming
What are the 3 functions of the Tailstock
Holding long work piece
Cutting a taper
Drilling functions
What are the 3 AXIS on a Bridgeport ?
X
Y
Z
When positioning a vise the handle of the vise should be to the right or left of the operator ? Why ?
Right
So if the drill catches it doesn't spin the vise into the operator
When using the disc sander the part should be sanded on the right or left side of the disc ? Why ?
Left
that is the rotation of the disc
G70
Incg Programming
Name the 5 major parts of the standard engine lathe
Headstock
Tailstock
Bad
Carriage
Feed Mechanism
What is the function of the knee?
To support the table/workpiece
What should be done with ALL tooling after using the Drill Press ?
Cleaned up and put away in the proper location
What should be done to every part after it has been cut on the horizontal band saw ? Why ?
Deburred
To prevent cut accidents.