Element 1
What is the title of Element 1?
Management Leadership and Organizational Commitment
What is the title of Element 2?
Hazard Assessment
What is the title of Element 3?
Hazard Control
What should you do before using a chemical you are unfamiliar with?
Review the SDS
How to call in sick for a shift?
Call the front desk during hours of operation. Speak with a Sr. Lifeguard or Janet directly.
What is the Town of Strathmore's Goal?
It is the intent of the Town to perform its work in the safest manner possible, consistent with safe work practices, and according to all governing laws and regulations.
What is the town of Strathmore's goal in relation to Element 2?
Being incident Free!!
What is a hazard control?
Hazard Control is a systematic approach to determine the best way to eliminate or control the hazards identified in Element 2 and ensure that employees are protected.
What are 6 of the sections included in a SDS?
How many muster points are there and what are the location(s)?
2 - Back parking lot, Skate Park
Yes or No, Is it the workers responsibility to be aware of the Occupational Health and Safety Act, Regulations and Codes?
Yes
What are the two factors that determine a hazards risk on the Risk Level Table?
Severity - How serious could the consequence of an uncontrolled hazard be.
Probability - The likelihood of something going wrong while performing the task.
What does SWP and SOP stand for
Safe Work Practice's
Standard Operating Procedure
What should you do if a SDS is unavailable for a chemical?
Do not use the chemical until one is found.
What is the MINIMUM PPE required when cleaning with any chemicals?
Gloves & Glasses
What are the 3 of 5 steps to performing tasks in a safe manner?
a) use and wear PPE
b)Notify Supervisor of any unsafe conditions or acts that may be a danger to themselves or other.
c) Report all incidents, including near misses to their supervisor by the end of every shift.
d) Comply with rules and regulations
e) Use Safe Work Practices Daily
If a hazard cannot be eliminated, what types of controls can be put in place to help control it?
First - Engineering Controls
Second - Administrative Controls
Third - Personal Protective Equipment
What are the 4 steps in hazard control?
Identify the hazards that may be present.
Assess the identified hazards to determine the risk they pose to workers.
Eliminate the hazards if possible.
Control any remaining hazards that could result in injury or illness.
Where is the booklet that has all the info if you are injured at work?
The Safety Board
Where do you put completed incident report forms?
Janets mailbox
What are the 4 ways that Supervisors and Leaders encourage participation in the Towns Health & Safety Management program?
1. Ensure that all employees are educated to work in a safe manner to perform tasks in a safe manner.
2. Ensure employees are aware of safe work practices and job procedures as required by this Town and by legislation to protect their H&S.
3. Ensure employees use all PPE.
4. Set a good example
What are the different methods the town uses to identify and address hazards?
1) Formal Hazard Assessment
2) Field Level Assessment
3) Project Hazard Assessment
4) Near Miss Report
What is the difference between a SWP and a SOP?
Safe Operating Procedures are written step-by-step instructions outlining how to perform a task with minimum risk to people, equipment, materials, environment, and processes.
Safe Work Practices are a simple list of do’s and don’ts that should be followed when performing a specific task.
What are an employee's three rights in health and safety? Explain each one
The right to refuse dangerous work and know that you're protected from reprisal.
The right to know about workplace hazards and have access to basic health and safety information.
The right to participate in health and safety discussions and health and safety committees.
What are the 4 steps to rolling up a hose?
Turn water off. Drain hose. Roll hose up. Close hose nozzle.