PLC
What does PLC stand for?
Programmable logic controller
A break contact will allow logical continuity if shown a _____
Capacitor impede ____ frequency signals
LOW
This IC mounting style uses "gull wing" style pins that lay onto of PCB connection points.
SMT
COMBINATIONAL
The device that keeps circuit voltages within a PLC from interfering or back feeding onto other circuits
OPTOCOUPLER/OPTOISOLATOR
IF a PLC program uses sentences as instructions this type of program is known as __________
Textual
What is a draw back to using a full wave CT rectifier?
SIZE &/OR COST
When working on circuits that contain IC's from this logic family, it is important to use a grounding strap attached to your wrist.
CMOS
This combinational logic device has one input and many outputs
DEMULTIPLEXER
This type of PLC system can have components added to it at will.
Modular
This type of memory is lost in power outage scenarios
Volatile
This type of rectification can be used on both Wye and delta electrical systems
3 phase Bridge
A IC with pins on all sides
ARRAY
This sequential device uses only one input signal along with a clock pulse to control its output
D latch
This type of PLC input/output module will have current flowing into the module and out of the input/output device
Sinking
This type of memory can have individual bits erased from it and can be rewritten
EEPROM
Power zener circuits have one draw back. what is it?
Inefficient due to resistor in series with collector.
How many Nibbles are in the number 1001 0011 00112?
3
This device will be driven into an invalid state if both inputs are high
SR latch
What does OTE stand for in terms of PLC outputs
Output enabled
Which type of non volatile memory can only be programmed once?
PROM (burning)
Other than a Zener diode what is the other device discussed that can regulate voltage?
OP-AMP
This logic gate has a high output when BOTH A and B are low
NOR
If the enable pin on a gated SR latch is low and its inputs change, what is the effect on its output?
no change/ LATCH