Change Overs
When do we 'finish Stack Twice" during a changeover
When moving from a wider to a narrower product.
How Many lockout points are on the Folder
2
What indicates when Your running Low on Stretch wrap?
LOW FILM ALARM
what is the purpose of the Vision system?
identify orientation of the bags
PPE REQUIRED IN THE FACING PIT??
Safety glasses, safety boots, hearing protection, high visability glasses, bump cap, cutting gloves
What do we say to confirm that we are done speaking on the radio ?
"OVER"
The Dump system transports Product to what section of the Auto Bagger?
Pinch Breaks
What is the base Temperature to set the glue pots for your run Roll?
72 F
What is the Part of the master bagger that Stacks the finished Product
Up-Stacker
how do you move the paper rolls to the stands
VIA CRANE/UPENDER
Pull a spinner
Where is the safety scanner for the Masterbagger located?
Underneath the Snout
The Roll Diameter is controlled by what piece of equipment??
Pressure roller
Where is the safety scanner for the Masterbagger located?
Under the Snout
What piece of paper would reflect the width of the facing paper required for the order change?
Production print out
What is the purpose of turning the AutoBaggers offline during a changeover?
To signify that the Autobaggers are not ready to take Product yet.
What communicates to the pinch breaks and tells them to release the batts
Photo eye
What is the correct name of the overwrapped used in Roll-up
polythene
How many safety gates and light curtains are on the Masterbagger?
9 gates, 3 light curtains
YOU SHOULD ALWAYS MEASURE _______ INCHES FROM THE BRASS GUIDE TO MAKE SURE YOU HAVE CORRECT MEASUREMENTS WHILE LOADING NEW FACING PAPER?
2 IN
When adjusting the snout stop position, the snout should always be what number of inches wider than the side wall???
1 IN
What part of the Autobagger finishes the final compression into the Cubbie
lid wheels
What piece of machinery is Stretch film used
Wulftec
Regarding the light tower above the vision system, explain the appropriate color for the represented message
Green- system in Auto
Blue- system in manual
Red- Area stopped
Yellow- Message on HMI
WHAT INFO DO YOU NEED TO CALCULATE TIME ON A CURRENT ROLE??
DIAMETER OF ROLL DIVIDED BY LINESPEED