miter saw
How far away from the blade should you keep your hand?
6"
True or false: you should always clamp your work when using a drill press
True
ticking
what should always be used with a belt/disc sanders
dust collectors
should the speed of the scroll saw be adjusted depending on the materials hardness
yes
True or false: You should always clamp your stock when cutting on the miter saw?
True
what is the name of the piece that hold the drill bit in a drill press
the chuck
what kind of cuts do you make to help cut out a tight curve
relief cuts
is the disc on a belt/disc sander multi directional
no
should the light be used for better visibility when cutting
yes
what should you use if you need multiple pieces of the same length
a stop block
where should the chuck key be when not in use
in its holder on top of the drill press
what is the purpose of a miter head
make straight even cuts
what is it called when the belt moves around the on the pulleys
belt walk
how should you avoid chatter when using the scroll saw
adjustt speed or make sure your holding it tightly to the table
What side of the miter saw is unsafe to stand at when in use
right side
what is it called when the drill bit leaves a nasty edge on the underside of your board
blow out
how high should the safety guard be above your stock
about a pink fingers width above
what happens if you hold wood in one spot for too long on the belt/disc sander
wood burn
what should be done first if you need to cut a shape out of the middle of the wood
drill a hole that is a little bigger than the blade
What is the measurement you should account for the blade when using a miter saw
1/8"
how can you prevent blow out on a piece of stock
putting a piece of scrap wood underneath
what is the slot on the table of the band saw for
miter head
how often should the belt/disc sander be cleaned
after heavy use
how do you remove the blade on a scroll saw
loosen the clamps on the top and bottom of the blade