Basic Safety
Companies with strong safety cultures usually have lower _____
what is Turn over?
Which factor determines the outcome of an electrical shock?
What is The size of the electrical equipment being used?
The center punch is best used to _____.
What is mark a point to start a drill?
Before replacing parts such as bits, blades, or discs on any tool, it is important to _____.
What is disconnect the power source?
Break lines are used to show that _____.
What is the only part of an object is represented to save space?
Poor lighting, excessive noise, and inadequate guards for moving parts are examples of ______
What is unsafe conditions?
The three basic causes of incidents are unsafe acts, unsafe equipment, and _____.
What is unsafe conditions?
The concave shape of a tape measure blade is designed to _____.
What is strengthen the blade when extended?
Before using a hammer drill or rotary hammer to drill into concrete, it is important to _____.
What is review silica exposure standards?
The triangular architect's scale is the most commonly used because it _____.
What is can combine multiple scales?
One source of lead on some job sites is _____.
what is paint?
If you bend from the waist to pick up an object weighing 20 pounds (9.07 kg), the amount of pressure applied to your lower back is _____.
What is 2 pounds (0.9 kg)?
Some chalk lines are also designed to serve as a _____.
What is plumb bob?
When using a circular saw, be sure to cut on the waste side of the cut mark to allow for the blade's _____.
What is kerf?
What are engineered plans for motors, pumps, piping systems, and piping equipment called?
What is Mechanical plans?
One of the most common grounding systems used for protection against accidental electrical shock is the _____.
what is a three-wire system?
Insulating gloves must be inspected by the user _____.
What is monthly?
A pipe clamp has _____.
What is a length of pipe for a spine?
Saws with fine blades that are excellent for delicate and intricate cutting are called _____.
What is a jigsaw?
Plans that show an aerial view of the building site location are called _____.
What is civil plans?
An unplanned event that may or may not result in property damage is known as a(n) _______
What is an incident?
NFPA 70E® provides practical guidance in _____.
What is fall protection procedures?
When compared to round and square shovels, a traditional spade _____.
What is is flatter and without curved sides?
The most important maintenance on a circular saw involves the _____.
What is the lower blade guard?
A dimension is a measurement written as a _____.
What is a number?