Safety
An employee does this when they find a hazardous situation on a job site
What is immediately report it to the supervisor?
This is 48 inches in feet
What is 4 feet?
This is used to cut a board to width
What is a RIP SAW?
This type of wood is more likely to be used for exterior framing work.
What is Pressure Treated Lumber?
This is the first step in installing windows.
What is Check the size of the rough opening?
This is what PASS stands for
What is PULL the pin
AIM at the base of the fire
SQUEEZE the handle
SWEEP side to side?
This is the most common scale used on blueprints
What is 1/4" = 1'?
This is used to set a finish nail below the surface of wood
What is a NAIL SET?
Galvanized casing nails are most commonly used installing this.
What is Exterior Trim?
When installing wood flooring on a concrete slab, this should be done first.
What is Install a moisture barrier over concrete slab?
This is what OSHA stands for
What is Occupational Safety and Health Administration?
This is 19' 4-1/2" in inches
232-1/2" inches?
This tool would be best for fastening gypsum board to walls
*Powder actuated driver *Corded drill
*Hammer drill *Screw gun
What is a Screw gun?
This is the best use of Carpenter's Wood Glue
A. As a lumber adhesive B. To bond plastic
C. For interior trim and cabinetry
D. To bond wood that is exposed to moisture
What is C. For interior trim and cabinetry?
This is a common name for an opening in the ceiling for attic access.
What is a Scuttle?
These are the steps you take if a large fire occurs at your job site.
What is leave the area immediately and notify emergency services?
This is the amount of baseboard needed for a living room that is 11' X 16'
What is 54 linear feet?
When using a power drill, make sure the bit is tight in this.
What is the Chuck?
These are the most frequently used nails when installing interior trim.
What are wire and brad nails?
This is the correct procedure when installing Gypsum wall board.
What is Install the top panels first?
Instructions for storing dangerous chemicals can be found on this
What is SDS?
(Safety Data Sheet)
This is 19' 4-1/2" in inches
What is 232-1/2"?
This tool is used to cut metal framing
What are Tin Snips?
This is the type of molding used around windows and doors
What is Casing?
Load Bearing walls provide this.
What is Structural Support?