This T.O. tells what configuration the fuel tanks need to be prior to mxs
What is 1C-130J-2-28JG-00-1
100
This normally-closed valve is installed in the line at the junction of the cross ship manifold and the Refuel/Defuel manifold to isolate these two manifolds.
What is the SPR valve
100
This is the percentage of foam removed that requires a contamination check
What is 25%
100
These tanks have four tank probes and one probe compensator unit
mounted on the wing top surface of each tank.
What are #2 & #3 Main Tanks
100
This monitors the fuel system and reports the status
over the data bus.
What is the FMC ( Fuel Management Controller )
200
Jettison Operational Check can be found here
What is 1C-130J-2-28JG-30-1
200
One automatic ______is located in each of the external, auxiliary, and
inboard main fuel tanks, with two automatic _____ located in each of the outboard main fuel tanks.
What is FLCV (Fuel Level Control Valves)
200
These 2 tanks contain 3 Vent Valves each
What are #1 & #4 Main Tanks
200
Each _______ tank has three internally mounted
tank probes and one probe compensator unit.
What are Aux tanks
200
This Closes the APU fuel shutoff valve.
What is the APU fire control T handle
300
This TO illustrates the correct screw locations for Top Panel Installation
What is 1C-130J-4-57-1
300
In the locked position, this fits flush with the wing
upper surface panel or external tank skin, as applicable.
What is a Filler Cap
300
The _________ do not have provisions for over-the-wing refueling.
What are Aux Tanks
300
This consists of an outer tube and base, a float, and a calibrated gage stick
with an armature mounted on its upper end
What is a Magnetic Site Gage
300
When closed, this
valve prevents fuel from a right wing fuel tank from feeding the left wing segment of the cross ship
manifold
What is the Cross Ship Separation Valve
400
Performing an A/C Battery Ops Check is covered here...
What is 1C-130J-2-24JG-30-1
400
this is provided to remove residual fuel from the SPR manifold after refueling or ground transfer.
What is SPR drain pump
400
Access to this tank is gained via the
outboard dry bays, through access doors in the inboard end of the tank.
What are 1 & 4 Mains, (Outbd Mains)
400
These probes are mounted
in such a way as to always be submerged in fuel. This is accomplished in the main fuel tanks by
mounting them in the surge boxes.
What are Comp Probes, (Compensator)
400
this will Energize a FLCV to open.
What is a tank transfer switch "to" position
500
The correct Installation of a manifold clamp is covered under this T.O
What is 1-1A-8
500
_________consists of a valve body, a primary and secondary piston, a primary and secondary
bleed shutoff valve, a primary and secondary float, a primary and secondary solenoid, and a
thermal relief valve.
What is a FLCV
500
The _________system maintains the surge box full of fuel.
What is the water removal/scavenge system
500
A __________may be used to check the fuel quantity in any main or external fuel
tank in the event the FMC is inoperative
What is a Dipstick
500
these are located on the aft side of
the wing front beam inside of each appropriate dry bay and allow fuel to flow too each engine.
What are Engine fuel shutoff valves ( Fire wall Shut off Valves)