Basic Questions
Fireground Hydraulics
Drafting
Tools and Equip.
Hose Manual
100

What angle do you position the appartus to the roadway between traffic and the work zone?

45 Degrees

100

Pressure generated by the weight of a column of water above the pump.

Back pressure aka Head Pressure

100

What is the maximum height to which water can actually be drafted? 

25 ft

100

According to PBCFR policy, when should any air cylinder be tagged and sent to the SCBA shop? 

With a hydrostatic test date that shall expire within 3 months of its 15 year service life. 

100

When laying a 5in supply line from the hydrant, if the attack engine is going to be more than ____ ft from the hydrant, a relay should be established. 

500

200

Traffic cones shall be deployed at _____ intervals _____ of the blocking apparatus with the furthest cone approx. ____ upstream. 

15 foot

Upstream

75 feet

200

What are the 6 principles of pressure?

Pg. 47 

Perpendicular, fluid at REST, Equally, Depth, Density, Independent. 

(Picked out key words from each)


200

On fire scenes, if you need additional sections of hard suction, how many sections do PBCFR engines carry? And how msny do PBCFR tenders carry?

two 10ft sections


three 10ft sections

200

Engines carry the Super Vac electric powered fan that flow up to how many cfm's? 

13,000 CFMs

200

When loading hose on a moving apparatus, hpw fast should it be driving and in what direction? 

no more than 5mph 

forward direction

300

A large percentage of accidents involving fire apparatus occur while doing what?

Backing

300

Name the FL and GPMs for PONN Conquest

100gpm-15 psi

150gpm-20 psi

185gpm-25 psi

200gpm-35 psi

300

When using the barrel strainer, the water must be a minimum of how deep? 

And requires how much water on all sides?

When using the floating strainer, the water should be how deep? 

4ft

2ft


18in

300

K12 blades cutting depths. 

A 14inch blade cuts how deep? 

A 12inch blade cuts how deep? 

5 inches

4 inches

300

When loading 3in hose, the female coupling should only protrude how many inches from the hose bed approximately?

18 inches

400

When flowing from the water tanks, you must notify command and crews when your tank drops to what percent? And then do what next?

25 % 

Perform emergency evacuation

400

Freightliner engines add ___ PSI to your appliance loss. 

Ground Moniotrs are____PSI.

FDC is ____ PSI. 

Rear Supply Aerial is ___ PSI. 

25

15

25

20

400

What is the most common cause of being unable to prime the fire pump?


An Air Leak

400

On the chainsaw when properly adjusted, how far should the slack hang? 

1/8inch on the underside of the bar. 

400

When hose testing, the total length of any hose line in the test layout should not exceed ???

300 feet 

500

What are Dry Hydrants marked with in the Water Source Locator? 

An orange hydrant symbol.

500

Current PBC code states that an FDC will be within how many feet of a hydrant? 

Also when pumping the FDC, it is recommended we do not exceed ___ PSI unless specified and marked as a high pressure system. 

100 


200

500

Name two indications of a possible clogged strainer. 


1. If you notice an increase in vacuum with a decrease in GPM.

2. If you throttle up, and the RPMs increaae, but the PDP does not rise with it. 

500

Gross Decon shall be located where? (what zone)

And which direction from rehab? And which direction from the hot zone?


In the warm zone and DOWNWIND from the rehab and Upwind from the incident hot zone. 

500

How long shall each hose layout hold and maintain the appropriate service test pressure?

When walking the lines, personnel shall remain a minimum of ___ ft to the ____ side of the hose.

Because when a rupture occurs, hose initially rolls to the ____.

3 minutes

15 ft, left

Right

M
e
n
u