The Code
These regulations shall be be known as the ____ ____ ____ ___.
Arkansas Fuel Gas Code
The code official shall make all of the required _____.
inspections
Air necessary for complete combustion of a fuel, including theoretical air and excess air.
combustion air
The outlet of a service meter assembly where the meter is not provided
Point of delivery
Air being removed from any space and conveyed directly to the atmosphere by means of opening or ducts
exhaust air
LP gas piping and systems shall be regulated by the ______.
Arkansas LP Gas Board
identification
The opening in a cap whereby the flow of gas is limited
Orifice
A double wall vent listed for use with appliances with draft hoods.
Type B Vent
An air compartment or chamber to which one or more ducts are connected and which forms par of an air distribution system
Furnace Plenum
The purpose of this code is to provide minimum standards to safeguard life, ______, ________, __________ and public welfare.
limb, health, property
The code official shall keep official records of applications received, __________, and __________ issued.
permits, certificates
The liquid that condenses from a gas caused by a reduction in temperature or increase in pressure
Condensate
An appliance designer or install so that the products of combustion are not conveyed directly to the outside atmosphere
unvented appliance
That which enables a device, appliance or equipment to be directly reached
ready access
The administrative authority (______ _________ ________ _________) is hereby authorized to enforce the provisions of this code
plumbing and fuel gas inspector
Reports of test shall be retained by the code official for the ________ required for retention of public records.
period
The pressure of the weight of air and water vapor on the surface of the earth, approximately 14.7 psi at sea level.
atmospheric pressure
Category of an appliance that operates with a nonpositive vent static pressure and with a vent gas temp that avoids excessive condensate production
Category I
An application for a permit for any proposed work may be deemed to have been abandoned _ days after filing.
180
These regulations cover piping systems for natural gas with an operating pressure of _____ pounds per square inch.
125
When the code official issues the permit where construction documents are required, the documents shall be endorses in writing and stamped ________.
approved
Abbreviation for the quantity of heat required to raise the temp of a pound of water 1 degree F.
BTU (British Thermal Unit)
Category of a an appliance that operates with a positive bent static pressure and with a vent gas temp that is capable of causing excessive condensate production in the vent
Category IV
A transition assembly in which plastic piping is installed and terminated above ground outside of a building
Anodeless Riser