Saftey
Hazards
Arc
MIG
Oxy-Acetylene
100

What do you NOT do in the shop?

Any Horseplay that may disrupt others

100

What happens when you don't wear glasses in the shop?

Increase the risk of injury to your eyes. 

100

What is a must have when Arc Welding to ensure you don't breath in toxic Fumes and Gases.

Proper Ventilation

100

What is one technique of MIG welding?

Push VS Pull or Gun Angle

100

What color is the Oxygen Cylinder Hose?

Green

200

What should you NOT do when you break a tool?

Leave it and not tell Mrs. Dinwiddie.

200

What is Propper PPE in the shop?

Glasses, Jeans, Close-Toed shoes, Jacket/Coveralls

200

Where is it appropriate to Arc Weld?

In a firesafe area

200

What do you do first when setting up to weld?

Propper PPE!!!! DUH

200

What color is the Acetylene Cylinder Hose?

Red

300

What should you be aware of when welding?

Your surroundings and yourself

300

Why do we use the right tools for the right purposes?

So we dont break them!

300

What is the preferred size of the electrode?

1/8 inch

300

Once your done welding, what do you do with the metal?

Remove spatter, and place it in the water

300

What does the Mixing Chamber do?

Mix Oxygen and Acetylene before exiting the torch

400

Why is it important to make sure your area is clean and organized?

It prevents accidents and minimal hazards. 

400

What would happen if you wore baggy clothes in the shop?

It could get stuck and/or jammed into something, increasing the risk of injury. 

400

What do you do when the base of your weld is hot?

Decrease the amperage 

400

What do you look for when inspecting your weld?

Cracks and other defects. 

400

What does the Oxygen regulator do?

It controls the flow of oxygen from the cylinder to the torch.

500

What do you do when its time to clean up?

Put tools away, and clean up your area.

500

When welding, what are some causes of Fumes and Gases?

Dizziness, nausea, lung damage, certain types of cancer

500

What happens when the amperage is too low?

The arc is week, its harder to start the arc, and the travel speed is low.

500

What is the #1 rule in MIG welding?

Saftey first

500

What does the Acetylene regulator do?

It controls the flow of acetylene from the cylinder to the torch.

M
e
n
u