When looking in the MEL for an aircraft writeup, you notice in large bold font the letters "FR" in the item description. What action do these letters entail for you as a maintainer?
This means an additional check (or verification) must be performed on a repetitive basis as specified in the MEL.
In which one of our maintenance manuals can you find out what different electronic symbols mean?
WDM or Wiring Diagram Manual
In what section of the FIM can you find the "EICAS message list" ?
Front Matter
What is TSgt Sisk's current beverage of choice?
Dr Pepper
What section of CAMP do you go to, to find out when routine maintenance is coming due on the jet?
Due List
Do maintenance level messages affect the airworthiness release of the airplane?
No - They do not require MEL consideration or maintenance action prior to dispatch.
4. Which of the following is true about the function of a transformer in an aircraft’s electrical system? (There is only one correct answer)
A) It converts electrical energy into mechanical energy
B) It steps voltage up or down to meet the needs of different electrical components
C) It stores electrical energy for later use
D) It acts as a backup power source for critical systems
B - It steps voltage up or down to meet the needs of different electrical components.
You notice the left hydraulic system Qty is reading high. Per the FIM you check level of the fluid in the sight gauge of the left system reservoir and notice the fluid is not above the center of the sight glass in the reservoir but the problem is still continuing. What part does the FIM say to replace with these current conditions?
The quantity transmitter M338
What does EGT have to read to require enriching the fuel to start the aircraft engine?
0 C
71 AMM
Yes
Page 4 of MOI 21-101
During your pre-flight walkaround inspection, you observe that a single flap track fairing on the left wing is missing. What manual and section of this manual would provide your limitations for this issue?
The MEL is the manual and the section of the MEL is the CDL.
What type of gate does this symbol represent?
AND gate
Per the FIM, what are the prerequisites to perform an APU bite test? (In regards to circuit breakers, only provide the amount of how many need to be pulled)
EICAS operative, 9 c/b's, External electrical power applied.
Yes- Check the aircraft parts listing
Bin 4
What section of CAMP allows you to enter aircraft times?
Flight Log
How many flights can you document on each flight log before having to move to a new flight log page? Why can you only do this number of flights on each page?
Two flights per flight log page and the reason for this is that there is only two air worthiness release blocks on each flight log page to document Daily or thru checks.
5. In aircraft avionics, what is the primary function of the rectifier?
A) To convert AC (alternating current) to DC (direct current)
B) To increase the voltage for the avionics systems
C) To prevent electrical interference in sensitive instruments
D) To regulate the power supply to the navigation equipment
A - To convert AC (alternating current) to DC (direct current)
Where is the P36 panel located? Hint: The FIM tells you
Main equipment center
What status is the jet in regard to the way wiring diagrams are illustrated?
Jet is on the ground with external power applied
In how many days is aircraft -41's new EGPWS Data base due?
42 Days
Pilots reported to you that they noticed a "L eng bleed off" advisory message during flight. What is the MEL sequence number and repair category letter for this specific issue?
36-11-01 and repair category letter C
What does this symbol stand for? (Think Randy's landing gear training)
Stand alone inverter
What FIM should you follow if you get the EICAS message "Cab Alt Auto 1"?
21-30 Fault Tree 803
What is the torque for the bolt used to hold the radome to the hinge? Assume the thread pitch is .2600
82 in lb to 88 in lb
20-11-00-912-001
Part BACB30NN
When is aircraft -41 due for a 4A check inspection?
30 April 2025
Extend the calendar filter out to May on the Due List