Hardware/ Tools
The two most commonly used torque wrenches are the setting or click type and what other?
Dial indicating
Fuselage
Which type of sealant is intended for surfaces sealing, overcoating fasteners, sealing joints and seams, fillet and brush sealing on integral fuel tanks and fuel cell cavities?
AMS-S-8802
Navy specifications require how many separate hydraulic systems for operating the primary flight control surfaces?
2
Only Support Equipment (SE) authorized per which publication will be used to dispense hydraulic fluid?
NAVAIR 01-1A-17
What are the three levels of Naval Aviation maintenance?
Organization, intermediate, and depot
What are the three principal parts of a bolt?
Head, thread and grip
What supports the engine, engine mount, and its accessories, and may or may not incorporate provisions for retractable landing gear?
Nacelle
Which type of sealant is intended for sealing surfaces and wet installation of fasteners on permanent structure?
MIL-PRF-81733
Directional control of the aircraft is accomplished about the _____ axis.
Vertical
What is the maximum contamination level for hydraulic systems in Naval aircraft?
Class 5
What type of maintenance level is performed at FRC's/AIMDs, and includes component inspection, disassembly, repair, reassembly, testing, and fabrication?
Intermediate
What type of nuts provide tight connections that will not loosen under vibrations?
Self-locking
What is the primary source of lateral control on fixed wing aircraft?
Ailerons
Sealant is considered to be in which condition if, when lightly touched, the sealant does not transfer onto the skin?
Tack-free
What flight control systems control pitch?
Elevators
The size of particulate matter in hydraulic fluid is measure in what?
Microns
The daily inspection is valid for a period of how many hours, provided no flight occurs during this period and no maintenance other than servicing has been performed?
72 hours
Dzus fasteners are available in how many types?
2
The H-60 has how many rotor blades that provide lift doe the helicopter?
4
What metal is often used in engine exhaust areas?
Titanium
What occurs when the main rotor rotates by air passing up through the rotor system instead of by the engine?
Autorotation
Prior to sampling, operate the SE for a minimum of how many minutes in a manner that will result in fluid flow through its reservoir to ensure uniform distribution of contaminants?
5 minutes
The A/M26U-4B (NAN-4) nitrogen-servicing unit is equipped with a boost pump that is capable of boosting nitrogen supply pressure up to a maximum of what psi?
3500 psi
Most of the rivets used in aircraft construction are made of what?
Aluminum alloy
For inspection and maintenance purposes, the entire tail section is considered a single unit of the airframe, and is referred to as the what?
Empennage
What is the publication for preservation of Naval aircraft?
NAVAIR 15-01-500
What is the upward bending of the blades caused by the combined forces of lift and centrifugal force?
Coning
Refer to what publication for any information regarding hoses and tubes.
NAVAIR 01-1A-20
What is the Plane Captain Designation form number?
OPNAV 4790/158