Line Status
Who sends line status?
What does a grey icon mean?
The instrument/node is offline.
What is the name for the special chemistry analyzers?
Centaur
When is it okay to reset the decapper waste?
Never
What is the last step when replacing a sealer reel?
reset the reel count
What time is line status sent?
as close to the 15th minute of the hour
Where can you find overload numbers?
Automation>Counters>Overload tab
What comes first, power cycling or reboot?
reboot
What is the first maintenance task done in the morning?
Clean the BIMs
Give directly to a Med Tech
The amount of samples that go into the HVS.
What does purple mean for the Advia 2120's?
red state, analyzer not ready, no rack available
If an analyzer is not responding, what is the first step to try and resolve the issue?
Soft reboot
Who is in charge of weekly dayshift/nightshift maintenance? and what are the responsibilities?
The second float
Day: Centrifuges, DSM, BIMs
Night: Sealers, decappers
Where is TBM 19 located on OP track?
If a BIM read rate is less than 60%, what do you do?
Check cameras for the BIM and escalate to an engineer if camera is not functioning correctly.
Data Management System
Where is the power cycle switch located on the Advia 2120's?
on the opposite side of the track behind the Advia
If a line is off and maintenance does not need/cannot be completed, what do we mark in ELL?
'No testing'
What do you need to do if you reboot a centrifuge?
Remove all samples from centrifuge and clear samples in DMS/GUI. Place back on line.
Who sees line status?
What HVS errors do ALO's recover?
Dumper Bin full, Wrong carrier flow
What is the next step for Auto Chemistry analyzers not receiving any samples?
If the ALO assigned to the line leaves because they work Saturday, who is responsible for the daily/nightly maintenance?
The first float. If the 1st float is gone, it is the responsibility of the second float.
When should you notify an Engineer about an HVS issue?
immediately