Portable Monitors
The UltraRAE 3000 measures what specific compound?
Piece of equipment that connects the Radius to SAFEROne and iNET.
What is a Gateway?
Password for all IPads that contain Incident Response Forms.
What is SafetyAmt?
Purpose of Community Exposure Guidelines.
What is to establish safe thresholds for community chemical exposure?
What is TWO?
The orientation of the arrow on the RAE-SEP tube when it is placed in the UltraRAE.
What is arrow pointing into the instrument?
Action taken to reach the "Menu" on the Radius.
What is pressing and holding both black buttons simultaneously?
Name of form that readings are recorded on.
What is Field Data Form?
The benzene community exposure guideline (CEG) 24 hr limit is ______ than the Marathon 8hr occupational exposure limit. (Higher/Lower)
What is Higher? 2ppm vs 1ppm
Correct response when approached by a community member during a deployment.
What is do not engage? Instead, provide the public relations phone number/contact card.
COPIES LOCATED ON DESK IN AMT EQUIPMENT ROOM
The lowest concentration units in which VOCs are measured by a MultiRAE.
What is PPB?
Number of Solar Radius locations throughout the plant
What is 10?
Checklist forms are required for these two (2) areas.
What are the EOC and Equipment Room?
The CEGs are based primarily on THIS agency's guidelines.
BONUS: NAME THE GUIDELINES
What is the US EPA?
BONUS: WHAT ARE THE ACUTE EXPOSURE GUIDELINE LEVELS (AEGLs)
Minimum hours of post-incident monitoring required for reportable events.
What is 4 hours?
The operational mode that the MultiRAE must be in before it is placed in the docking station to bump or calibrate (ON or OFF).
What is OFF?
LEL sensor technology used by the Radius.
What is Catalytic Bead?
Location of electronic copies of all forms.
What is the AMT Teams Page?
What is Does?
This device should be used for all AMT deployment data collection.
What is the IPad?
Name of the monitor that measures particle size and concentration.
DusTrak DRX
Toxic specific sensors that can be measured by Radius monitors at MRD.
What are CO, H2S, SO2, NH3?
Name of form required to be completed following an incident.
BONUS: WHAT DROVE THIS REQUIREMENT?
What is the Post-Incident Community Air Monitoring Form? (PICAM)
BONUS: CONSENT ORDER
THIS is the 4hr CEG for Ammonia.
What is 30ppm?
This must be completed on equipment prior to leaving after an event.
What is the post-incident bump test?