Chemical Synthesis
This describes the formation of a compound that contains an alkyl group.
What is "esterification"?
These are the two main purification strategies when using solid-phase extraction.
What are bind-wash-elute & passthrough cleanup?
Desorption of analytes from solid-phase microextraction fibres is dependent on these three factors.
What are:
- analyte boiling point,
-inlet temperature, and
-fibre thickness?
This is a form of ELISA wherein antibody is bound to a substrate, sample is added, and more antibodies are used for detection.
What is sandwich ELISA?
BONUS This classmate plays for a national level soccer team.
Who is Fiston?
This analytical test is most useful for seeing whether there was any starting material left at the end of the reaction.
What is the ferric chloride test?
What is Empower?
Use of internal standards during our pesticide analysis required this calculation, comparing area and concentration of target analyte vs. internal standard component.
What is calculation of relative response factor (RRF)?
This step of the ELISA prevents antibody from binding to off-target sites.
What is blocking?
These were the two media in the mixed-mode SPE cartridges used during anthocyanin purification.
What are cation exchange and C18 resins?
This result on a melting test would suggest that your product has something unintended in it.
What is a different melting range than the standard?
BONUS- This is Marla's dog's name
Salty (Salt, Saltydog, Dude)
These two steps are required for Quechers preparation of pesticides.
What are extraction (using salts) and purification (using dSPE)?
This rarely-used form of ELISA has the advantage of being excellent for detecting very small antigens
What is competitive ELISA?
Calculation of total anthocyanin concentration in samples using Beer Lambert equation required these three values?
What are absorbance, pathlength, and molar absorptivity coefficient.
This is the water-soluble byproduct obtained in the chemical synthesis of aspirin.
What is acetic acid?
In reverse phase chromatography, this is the most polar phase.
What is the mobile phase?
This is the gradient that varies during GC analysis.
What is oven temperature?
When performing ELISA, this step should be taken if it is anticipated that there will be a very high amount of unknown antigen in the samples.
What is sample dilution?
This measure of process efficiency is represented by the total amount of analyte entering a system compared to the total recovery.
What is mass balance? (yield)
Yield is calculated by dividing the amount of product you obtained by this number, then multiplying by 100.
What is the amount of product you should have obtained?
To change the resolution of peaks on UPLC, these two method parameters should be considered.
What are gradient and flow rate?
This GC parameter introduces the entire sample into the gas chromatograph, typically used for trace analysis and solid-phase microextraction.
What is splitless injection?
This property of TNFa made it more suitable for quantification by ELISA than by Western blot.
What is being a "released factor"?
These are the central aglycone structures of anthocyanin molecules.
What are anthocyanidins?