HEALTH
NAME 3 TYPES OF SPILLS THAT MUST BE REPORTED
NON-HAZARDOUS CHEMICALS, GASOLINE, DIESEL, LUBRICANTS THAT EXCEED 5 GALLONS
SPILLS THAT ENTER SURFACE WATER SYSTEMS
HAZARDOUS CHEMICALS
NAME THE 3 PARTS OF THE EAR
THE OUTER EAR
THE MIDDLE EAR
THE INNER EAR
SHORTNESS OF BREATH, WEAKNESS AND SEVERE COUGH ARE SIGNS OF WHICH 2 IRREVERSIBLE LUNG CONDITIONS
PNEUMOCONIOSIS AND SILICOSIS
NAME 6 SPILL MANAGEMENT PRACTICES
AVOID SPILLS
GOOD HOUSEKEEPING
PREVENTATIVE MAINTENANCE
SPILL PREVENTION AND RESOPNSE PROCEDURES
WASTE MANAGEMENT
INSPECTIONS
WHAT IS THE FOOTAGE REQUIREMENT FOR TRACKING MINERS UNDERGROUND
200 FEET SPECIFIED AREAS
2000 FEET PRIMARY AND SECONDARY ESCAPEWAYS
4000 FEET BELTLINES
NAME THE 14 INJURY TYPES
SM,SS,SL,SA,CBY,CW,CO,CB,CI,FS,FB,E,FBE,O
WHAT IS A DECIBEL
MEASURE OF SOUND PRESSURE
NAME 4 CONTROLS TO LIMIT DUST EXPOSURE
WATER, VENTILATION, DUST COLLECTION, AND PPE
OUTSIDE AWARENESS ZONE-GREEN LIGHT ON PROX + EQUIPMENT-NORMAL OPERATION
WARNING ZONE-YELLOW LIGHT AND BEEPING TONE ON PROX + FLASHING YELLOW ON EQUIPMENT-AUTOMATICALLY SLOWS
SHUTDOWN ZONE-CONTSTANT RED LIGHT AND CONSTANT ALARM ON PROX + CONSTANT RED LIGHT ON EQUIPMENT-MACHINE TRAM AND CONVEYOR SWING SHUTS DOWN
NAME 5 LOCATIONS THE TRACKING SYSTEM MUST COMMUNICATE UNINTERRUPTED
PRIMARY AND SECONDARY ESCAPEWAYS, SCSR CACHES, POWER CENTERS, WORKING SECTIONS, REFUGE ALTERNATIVES
WHAT IS THE PURPOSE OF A CPDM UNIT
PROVIDE A CONTINUOUS READOUT OF RESPIRABLE COAL MINE DUST CONCENTRATIONS DURING THE WORK SHIFT
PROVIDES LAST 15-MINUTE AVERAGE FOR SHORT TERM SAMPLES
PROVIDES LAST 30-MINUTE AVERAGE FOR FULL SHIFT SAMPLES
STORES SAMPLE DATA FOR FUTURE DOWNLOAD AND ANALYSIS
NAME THE 2 TYPES OF HEARING LOSS
TEMPORARY AND PERMANENT
1.5MG/CUBIC METER IN ACTIVE WORKINGS
0.5MG/CUBIC METER WITHIN 200 FEET OUTBY THE WORKING FACES
0.1MG/CUBIC METER OF RESPIRABLE QUARTZ IN ACTIVE WORKINGS
NAME THE 6 STEPS OF THE SPILL RESPONSE PLAN
KNOW THE HAZARD AND SAFE HANDLING REQUIREMENTS
STOP THE LEAK
CONTAIN THE SPILL
COLLECT MATERIAL INTO DISPOSAL CONTAINERS
LABEL CONTAINERS PROPERLY
DISPOSE OF PROPERLY
NAME 6 OF THE COMMUNICATION AND TRACKING COMPONENTS IN SERVICE UNDERGROUND
IWT RADIO, IWT PERSONAL TAG(TRACKER), ANTENNAS, BEACON, FIXED MESH NODE, BATTERY MESH NODE, PAGER PHONE, LAND LINE PHONE,
NAME ALL 5 CATEGORIES OF THE GCC EYE PROTECTION PROGRAM
SAFETY GLASSES ANSI APPROVED WITH SIDE SHIELDS WORN AT ALL TIMES EXCEPT WHEN IN THE OFFICES, BATHHOUSE, AND PARKING AREAS
PERSONS USING CUTTING TORCHES SHALL WEAR GOGGLES OR SHADE 5 SAFETY GLASSES WITH A FACE SHIELD
COMBINATION OF SAFETY GLASSES AND A FACE SHIELD SHALL BE WORN WHILE OPERATING GRINDER OR WITHIN 5 FEET OF GRINDING OPERATIONS. SAFETY GLASSES SHALL BE WORN BY ANYONE WITHIN 25 FEET.
PERSONS USING ARC WILDERS OR ASSISTING IN WELDING OPERATIONS SHALL WEAR A FULL FACE SHIELD EQUIPPED WITH A SHADE 10 OR DARKER LENS. AN ELECTRONIC LENS THAT DARKENS WHEN AN ARC IS STRUCK IS ACCEPTABLE
SAFETY GLASSES AND FULL FACE SHIELD SHALL BE WORN WHILE USING COMPRESSED AIR OR HIGH-PRESSURE WATER
NAME THE 5 STEPS OF THE HEARING CONSERVATION PROGRAM
MONITORING SYSTEM, HEARING PROTECTION, AUDIOMETRIC TESTING, TRAINING, RECORDKEEPING
NAME 5 COMPONENTS OF A CPDM PUMP
SAMPLE INLET ASSEMBLY, SAMPLE LINE(TUBE), BLOCK WITH FLOW RESTRICTOR ORIFICE, GRIT POT, BATTERY, FOAM SPACER, DISPLAY, AIR HEATER, PUMP, SAMPLE FILTER, MASS TRANSDUCER
NAME 3 PARTS OF THE PROXIMITY DETECTION STANDARD
EACH MINER IN THE WORKING SECTION MUST WEAR A PROX LOCATOR
A DESIGNATED PERSON MUST PERFORM A CHECK ON THE MACHINE MOUNTED COMPONENTS
CHECK FOR PROPER OPERATION OF THE MINER WEARABLE COMPONENT
THESE CHECKS ARE PERFORMED AND DOCUMENTED IN THE DUST PARAMETERS ONSHIFT BEFORE MINING
PROX LOCATORS MUST BE PROPERLY CALIBRATED BEFORE BEING PUT INTO SERVICE UNDERGROUND
WHAT MUST HAPPEN AFTER THE WEEKLY EXAMINATION REQUIREMTENTS FOR THE COMMUNICATION SYSTEMS INFRASTRUCTURE HAS BEEN COMPLETED
RECORD OF OF THE EXAMINATION WILL BE RECORDED AND MAINTAINED FOR 1 YEAR, ANY REPAIRS/MAINTENANCE WERE COMPLETED AND DOCUMENTED, MADE AVAILABLE TO AN AUTHOURIZED REPRESENTATIVE OF THE SECRETARY, AND COUNTERSIGNED
NAME 9 PURPOSES OF THE MSDS
IDENTIFY
PROPERTIES-CHARACTERISTICS SUCH AS VAPOR PRESSURE OR WATER SOLUBILITY
PHYSICAL HAZARDS- FIRE, EXPLOSION, AND REACTIVITY
HEALTH HAZARDS- SIGNS AND SYMPTOMS, MEDICAL CONDITIONS, ROUTE OF ENTRY
EXPOSURE LIMITS- PERMISSIBLE LIMIT AND MANUFACTURER RECOMMENDATIONS
CARCONOGENICITY- CANCER CAUSING
SAFE USE- HYGIENE PRACTICES, CONTAMINATION, SPILL/CLEAN UP PROCEDURES
CONTROL MEASURE- PPE, WORK PRACTICES, ENGINEERING CONTROLS
EMERGENCY INFO- EMERGENCY, FIRST AID, AND CONTACT PROCEDURES
WHAT ARE THE 3 LEVELS OF THE NOISE STANDARD
ACTION LEVEL 85 DB
PERMISSIBLE EXPOSURE LEVEL 90 DB
DUAL PROTECTION LEVEL 105 DB
NAME 5 REQUIREMENTS OF CPDM OR CMDPSU SAMPLING
SAMPLING IS PORTAL TO PORTAL, ENSURE PROPER LOCATION, FLOWRATE, AND OPERATION, ENSURE ENVIRONMENT IS WITHIN THE DUST STANDARD, CPDM CHECKED AT MIDSHIFT OR WHAT IS SPECIFIED IN VENT PLAN, CMDPSU CHECKED THE SECOND HOUR AFTER BEING PUT INTO OPERATION AND THE LAST HOUR, 2.0 LITERS PER MINUTE CMDPSU, 2.2 LITERS PER MINUTE CPDM, CHECKED WITHIN 3 HOURS PRIOR TO SAMPLING SHIFT, WORN WITHIN 36IN OF BREATHING ZONE, RESULTS TRANSMITTED WITHIN 24 HOURS, DUST DATA RESULTS POSTED WITHIN 12 HOURS, MSHA REPORT OF RESULTS POSTED FOR 31 DAYS, RECORDS SAVED FOR 1 YEAR, 15 VALID SAMPLES FOR DO'S AND ODO'S, 1 VALID SAMPLE FOR DWP, 5 VALID DA SAMPLES,
NAME 5 STRUCTURAL MANAGEMENT PRACTICES
SEDIMENT AND EROSION CONTROL
SECONDARY CONTAINMENT
STORMWATER EXPOSURE CONTROL
MANAGEMENT OF RUNOFF
COVERING OF RAW MATERIALS
EXPLAIN THE BACK-UP COMMUNICATION PROCEDURE IN THE EVENT OF THE IWT COMMUNICATION SYSTEM FAILURE
NOTIFICATION OF THE AFFECTED AREA VIA BACKUP COMMUNICATION SYSTEM, INCLUDE THE NATURE OF THE FAILURE, THE EXTENT OF THE SYSTEM AFFECTED BY THE FAILURE, THE MANNER IN WHICH THE FAILURE WILL BE CORRECTED. UNTIL SUCH TIME AS THE SYSTEM HAS BEEN RESTORED TO FULLY FUNCTIONAL MANNER AND THE AFFECTED AREA HAS BEEN NOTIFIED.