Left or Right?
It comes from BIN 1 unless it comes from BIN 2.
What is the return conveyor?
Both green safety loop indicator lights on PDC cabinet are lit when this relay is energized.
What is K9?
It gives main power connection to the entire machine.
What is CB1?
This track is called "Lit", referring to the (LD1) means this item is "blown".
What is the F1 fuse?
The Main CPU display is lit when this Relay is energized.
What is K14?
It is where you start / stop the machine and it contains all main power relays.
What is PDC (A)?
The E-stop hardware loop voltage when measured to ground should be this.
What is 33 VAC?
It includes initial power, E-stop verification and sequence 1, all of which occurs when CB1 is shut.
What is "Ready Preset"?
When "The lights are out" referring to LD2 and LD4, everyone knows to replace this.
What is the F2 fuse?
This is accessed by pressing Menu, selecting 1 and entering the password.
What is the "Maintenance Menu"?
Jackscrews for adjustment are located here.
What is the take up module (C)?
After safety loop voltage is stepped down VIA T3 to 33VAC it goes through this CB.
What is CB 8?
L1, L2, and L3 supply this voltage to APBS through CB1.
What is 3-phase 208 VAC?
"Swapping" is a provocative track referring to this plug at the top of the MC70 that can be changed safely with power on.
What is the J1 plug?
This is the connection plug for the System Work Station.
What is P4?
Always on the left side and always counting cells.
What is the cell count and zero count sensors?
These are the only Output Stations with E-stops, except in the JLC module.
What is A11 & A12?
Known as "The first Klunk"
What is K14?
"NO" is a heavy hitting tune that lets everyone know that this plug is powered up when the machine is on and should not be "Hot Swapped"
What is the J2 plug?
This Input on the CPU is for the "Start" pushbutton.
What is IN1?
The first point of tracking on the machine.
What is the DS 27 / 28 PE pair?
This is the number of stack light assemblies on a 100 BIN machine.
What is 3?
This sequence starts after a 3.4sec delay when relay K10 energizes.
What is sequence 4
Every club plays this song because every address on each Induct Code (A3) card is this.
What is A1?
The CAN Bus connection on the CPU uses this type of cable interface.
What is RS-232?