Numbers
How many time can a part be Decontaminated
3X max
One Wet, Two dry.
When applying adhesive, the Urethane Gun should always be held at
90 degree angle to the glass or pinchweld
Approved, Proprietary Glass Stand We use.
The GTS
Surface treatment Flash off time above 20 degrees
2 minutes
What is the correct process for a pinchweld that has No scraches or issues, after the full cut method was used
Apply Betaseal Apex Urethane within two hours
What is the maximum amount of times a windshield can be treated with Surface Treatment
2X max
(Clear glass on exception)
True or false?
Safety glasses are required at all times while in a shop environment
True
First Scraper we use
BTB
Surface treatment Flash off time below 20 degrees
6 minutes
what is the correct sequence of steps for preparing a pinchweld that has rust free, bare metal that is more than 1/2" squared but less than 24" square
Scuff, Clean with glass cleaner, trim PUR to 1-2 mm, Apply 2 coats Surface Treatment
What grit sandpaper do we use on polycarbonate parts
100 Grit sandpaper
Brushing and scrubbing the pinchweld with glass cleaner should be done when
Before trimming the urethane
Secondary Scraper WE use
Belron Scraper
Apex urethane cannot be used at an ambient temperature below what
0 Degrees
What is not an acceptable rust repair from the body shop
The damage is filled with Body Filler
what is the optimal temperature for the apex urethane
65-70 degrees
When using the Surface treatment from the can, how many times and you dip a dauber or melamine sponge into the can
Only once to prevent contaminating the remaining material in the can.
(never double dip your dauber)
Windshield cut out tool
EZI-WIRE
When using Surface Treatment scratches or baremetal areas must be overlapped by how much
1/8th"
When working on an aluminum pinchweld, why should you never use the same abrasive tools that were previously used on steel
The particles of different metals will transfer and cause Galvanic corrosion on the aluminum
How many hours can a part be treated with surface treatment before the surface treatment must be reapplied
72 hours
(Three days)
How is FMVSS 212/208 tested
30 mile an hour barrier crash
Too be used to seam urethane
Seam Stick, (popsicle stick)
Technicians must always use _____ when using chemicals, and _______ when handling glass.
Nitriles, and Cut resistant
Which is the correct process for preparing a pinchweld that has rust free, baremetal less than 1/2" square
Clean pinchweld, trim PUR to 1-2 mm, apply 1 coat Apex Surface Treatment