True seal
1-tek
1-tek
Unit that goes on the windshield?
Windshield Unit
Whats the name of the guy in all of the Training videos?
Coltons DAD! (Brent Sutton)
Why is it necessary to recheck after the decontamination step?
To verify the process was successful in removing the contamination
A windshield should NOT be bonded to a pinchweld when the body shop has fixed the area with?
Body filler
What height do we trim the urethane down to?
1-2mm
Unit that goes on the Driver Door glass?
Base unit
When will the trainee shirts come in?
Never!
Contamination must be identified before completing the decontamination process. After spraying the bond line what are we looking for?
The glass cleaner to migrate or change in appearance.
If dirt or debris remain on the bond line after trimming, the correct process to prepare the dirty area for bonding is to?
Spot clean as needed with glass cleaner and a clean paper towel.
All open Surface treatment cans must have an open date. What should you do if you discover a can open that does not have the open date written on it?
Properly dispose of it immediately.
When mounting the Base unit to the door glass, Where are we looking for the bubble in the level to move?
To the left to the left. Everything i own is in a box to the left, In the closet thats my stuff...
Safelite Repair?
Safelite Replace!
A metal framed slider is correctly prepared when you
Decontaminate, Apply glass cleaner, Wet scrub with an abrasive pad, Final wash, 1 coat Surface treatment.
When do we brush, then scrub the pinchweld?
Before trimming.
The technician must always do what? Before preforming the Pre-inspection on the vehicle?
Inspect the glass. If it does not match or is damaged. Nothing else matters.
Is it called True seal Or 1-tek?
Both.
Class Mantra
Do whats Right!
How do we prep a polycarbonate part for installation?
Decontaminate, Scuff with 100 grit sandpaper, final wash, 1 coat of surface treatment.
Pinchweld prep less than 1/2" squared of bare metal
Clean pinchweld, Trim urethane to 1-2 mm, ! coat of surface treatment.
All safelite associates must use ____ when handling glass, and _____ for handling chemicals?
Cut resistant/nitrile gloves
Why is it necessary to clean your cups when they are brand new?
Because they will have contaminates and mold release agents on them.
where is the best place you will ever work?
McDonalds!
...JK Safelite!
How do we prep a PRE-APPLIED ADHESIVE SYSTEM (PAAS)?
Decontaminate, Apply glass cleaner, scrub with an abrasive pad, final wash, 1 coat of surface treatment.
A pinchweld with holes or corrosion that is greater than 24" squared is correctly prepared when you?
Body shop restoration, Scuff with abrasive pad, clean with glass cleaner, trim remaining PUR to 1-2mm, apply 2 coats Surface treatment.
What are the proper steps for using the metal cleaner prep stick during a rust treatment procedure?
Apply to bright shiny metal, Wait 5 Minutes, Wipe with (WET) water.