TWO STAGE
All panels or components with a base refinish time of less than 1.0 hour
What is a major panel
First panel:– Add 40% to refinish time • Each additional panel:– Add 30% to refinish time in considered.
What is two tone
• First major panel:– Add 70% to refinish time • Each additional panel:– Add 40% to refinish time
What is three stage?
• First inner part:- Use full published time • Each additional inner part with a base time of 0.5 hour or greater:- Deduct 0.2 per part • Inner part wit
What is OVER LAP INNER PANEL
All panels or components with a base refinish time of 1.0 hour or greater
Motors defines a Major Panel?
edges, jambs, hinges, inside panels and the underside of hoods, deck lids, liftgates
No overlap deduction should be taken when calculating refinish time for items from this category.
Each panel requiring de-nibbing (refinish or blend) HOOD, ROOF, TRUNK LID, SPOILER First panel add up to 20% of full base refinish time, each additional panel add up to 10% FENDER, DOOR, QUARTER PANEL, BUMPER COVER First panel add up to 10% of full base refinish time, each additional panel add up to 5% refers to?
What is De nib and polish
First major panel:– Add 40% to refinish time • Each additional panel:– Add 20% to refinish time • Maximum time allocation:– 2.5 hours
what is max clear coat?
No restrictions with overlap
What is exterior overlap?
This includes Clear Coat application.
What is a Blend?
The letter "P" represents?
What is paint time
25% of the component's base refinish time • Maximum time allocation: 1.0 hours refers to>
What is unprimed prep formula
Repair beyond 150 grit.
What is a Block & Sand?
A component manufactured to the same exacting standards as the parts installed on new vehicles when the car was built. Exterior body panels are supplied with a smooth painted surface (e-coat).
What makes a a new undamaged panel?
Each additional panel: – Add 40% to refinish time
What is the clear coat calculation for additional panel under Three Stage?
Plastic and steel components are defined as?
What is a substrate.
Each panel requiring wet sand, rub-out and/or buff (refinish or blend)– Add 30% of full base refinish time
What is WSB
First major panel:– Use full published time • Each additional part:– Deduct 0.2 per part
What is overlap non adjacent panels?
This is never wet sanded after completing painting.
What is Matte/FLAT FINISHES?
First panel: – Add 0.5 per panel • Each additional panel: – Add 0.3 per pane
What is Stone Chip Guard?
First panel:– Add 0.5 per panel • Each additional panel:– Add 0.3 per panel is known as?
What is the chip guard formula
INCLUDED: • Removal of mold-release agents as outlined by manufacturer • Masking (if required) • Application of adhesion promoter
What is included w/ bumper prep?
First major panel:– Use full published time • Each additional part with a base time of 1.0 hour or greater:– Deduct 0.4 per part • Each additional part with a base time less than 1.0 hour:– Deduct 0.2 per part
What is OVERLAP – ADJACENT PARTS
Refinish times do not include removal of mold release agent from new unprimed molded components.
What is bumper paint allowance? see Unprimed Flexible Component Preparation on page G39.
Bumpers and other flexible components can only receive a maximum refinish overlap deduction of 0.2 hour.
What is overlap non adjacent panels?