1
2
3
4
5
100
These commands are meant to apply a _______ to a sketch or form.
Pattern
100
This command is used to ______ a form.
Revolve
100
This command is used to _____ a form.
Loft
100
This command is used to ______ a feature on a form.
Emboss
100
This command is used to create a _________________.
Midplane between two planes.
200
This command is used to create a ________ pattern.
Circular
200
What is this constrain?
Tangent
200
What constraint would be used to create the before and after picture below?
Perpendicular
200
What constraint would be used to create the before and after picture below?
Coincident
200
What command would be used to create the before and after picture below?
Fillet
300
What command would be used to create the before and after picture below?
Slice Graphics
300
What command would be used to create the before and after picture below?
Offset
300
What command would be used to create the before and after picture below?
Revolve
300
What command would be used to create the before and after picture below?
Loft
300
What type of work plane is used in the picture below?
Offset from Plane
400
What command would be used to create the before and after picture below?
Chamfer
400
What command would be used to create the before and after picture below?
Circular Pattern
400
What command would be used to create the before and after picture below?
Shell
400
This command is used to put a ________ on the edge of a part.
Fillet
400
This command is used to ______ a form.
Chamfer
500
This command is used to ____________ from a sketch.
Project Geometry
500
This command is used to ______ duplicate geometry of a sketch.
Offset
500
This command is used to create an _____ line.
Axis
500
This command is used to create a ______ on a sketch or form.
Mirror
500
What is this constraint?
Horizontal