Physical Layer
Design Fundamentals
Controllers
Mobility Services
Deployment Modes
100
This is the standard protocol for WLANs.
What is IEEE 802.11?
100
When setting up APs for data applications only the antennas should be set at the % of power.
What is 60%?
100
The controller on the SRE within and ISR G2 can accommodate this maximum number of Access Points.
What is 50?
100
This mobility service has advanced beam forming technology.
What is ClientLink?
100
This deployment mode would be used if someone did not consult with someone that completed the CSAP program for advice ;).
What is an Ad Hoc network?
200
A gain of 3dB will magnify the power output by this much.
What is the power of two?
200
If configuring a WLAN for voice and data a good base idea to work from is to have one access point per ___ square feet.
What is 3000 square feet?
200
This WLC can be used for either small branch or large campus deployments.
What is the Catalyst 3850?
200
This Cisco technology provides reliable multicast over wireless.
What is VideoStream?
200
This Cisco protocol is used in a centralized deployment mode for communication between the AP and the WLC.
What is LWAPP?
300
This indicator will describe the amount of noise received.
What is the Signal to Noise Ration (SNR)?
300
When configuring a WLAN for video support this is the maximum number of clients per AP that should be planned for.
What is 20?
300
The WiSM2 WLC can support this number of concurrent AP joins.
What is 1,000?
300
This indoor access point in the 6 series does not support any version of Cisco's CleanAir Technology.
What is the Aironet 600?
300
802.11i authentication is handled by this device in a Centralized deployment mode.
What is the WLAN Controller?
400
A Clear to Send (CTS) frame is this type of frame.
What is a Control Frame?
400
When deploying a WLAN to support location services it is necessary for this number of APs in order for triangulation to be effective.
What is three?
400
These are the two WLCs that are common criteria certified.
What is the 5500 series and the WiSM2?
400
The wIPS security feature requires the addition of this product to the network.
What is the 3300 Series Mobility Services Engine?
400
If deploying repeaters requires an overlap of this percentage with both the APs and repeaters.
What is 50%?
500
A probe request is this type of frame.
What is a Management frame?
500
If deploying a WLAN in an 87,000 square foot space this number of access points would be recommended.
What is 18?
500
This is the maximum number of RF tags that the WiSM2 WLC can support.
What is 5,000?
500
Consistent application of a client access policy can be added to a network through the addition of this mobility service.
What is the Identity Service Engine (ISE)?
500
What is the average speed of the wild panther?
What is 50 mph?
M
e
n
u