Spinning Round
Tire size markings include?
Letters and Numbers
Semi independent suspension is found on?
Rear of front wheel drive vehicles.
What is the purpose of a stabilizer bar?
To reduce body roll and lean when cornering
To correct for negative or positive thrust angle, rear wheel _____ is adjusted.
Toe
A customer complaint of hard steering may be caused simply by _________________
Low Tire Pressure
TPMS turns on when the tire is?
A tire is 25 percent lower than placard for 20 minutes.
Supports the weight of the vehicle.
Springs
Modified strut suspensions relocate the spring away from the ______.
Strut
During an inspection of a ball joint, the wear indicator is found to be receded into the socket housing. What does this indicate?
Worn Ball Joint
The steering wheel indicator light is used to warn the driver of a ______ in the electric assist system.
Fault
Tire and wheel out of Round
Radial Runout
Shock Absorbers are also called.
Dampers
Torsion bar suspension is used in many ______ vehicles.
4WD
During an inspection, the spring bumper is found to be shiny. What does this indicate?
Worn Springs
To bleed air from a power steering system with the engine running,
Turn the steering wheel side to side
Describes the position of the mounting surface compared to the center of wheel depth
Wheel Offset
With a __________ suspension, the steering knuckle is taller than a traditional strut or SLA suspension, often reaching the height of the top of the tire.
Multilink Suspension
Control arm bushings are common ______ items and require replacement.
Wear
The _____ keeps the linkage level and supported to prevent bump steer.
Idler Arm
A ___________ check places a high load on the steering and suspension components to check for loose joints and other parts.
Dry Park Test
A common leak area on a tire.
Around the bead for corrosion buildup.
_____ occurs when the wheel hits a bump and moves downward.
Rebound
_____ fittings, are fittings threaded into a component for the injection of grease.
Zerk
What component connects the steering gearbox to the steering linkage?
Pitman Arm
A tire is being inspected. The technician finds excessive wear on one edge of the tire. What could be the cause?
Camber out of adjustment.