Tools
You lay on these to work under a vehicle when a lift is not in use.
What is a creeper.
What is the minimum tread depth allowed on inspections in NYS?
What is 2/32"
What can an electrical cause due to the heat of current flow?
What is a burn
What is the main function of an automotive battery?
What is to power the starter motor
The hydraulic brake system input cylinder is called what?
What is the master cylinder
These are used to raise a vehicle up off the floor and you never work under a car supported only by them.
What is a floor jack.
What is the rim size for a tire a tire measurement of 285/75R-15?
What is 15
This is the primary tool to make voltage, amperage, and resistance measurements.
What is a DMM or Digital Multimeter
A full charged automotive battery produces how much voltage per cell?
What is 2.1
What are the most common type of calipers used on modern cars and light trucks?
What are floating calipers
All of the following are common rachet and socket drive sizes except:
1/4 inch
1/8 inches
3/4 inch
1/2 inch
What is 1/8 inch
These types of tires are used on the majority of passenger cars.
What are all season
What is the formula to determine amperage?
What is: Amps = Volts / Resistance
V
______
A | R
What temperature, in *F, are cold cranking amps based on?
What is zero degrees
Wheel cylinders are used with which type of braking system?
What is drum brakes
This tool can be used to check for power, ground, current flow, and continuity.
What is a test light
A hub-centric wheel is a wheel centered to the vehicle by what?
What is the hub
What is the formula to determine volts?
What is Volts = Amps x Resestance
V
_______
A | R
What is sulfuric acid and water
This type of tool is used to make new flares on a brake lines.
What is a flaring tool
These are types of tools that are connected to compressed air hoses.
What are pneumatic tools.
What are the two types of TPMS?
What are direct and indirect
What is the name of the law that defines how amps, voltage and resistance interact?
What is Ohm's Law
What temperature, in *F, are cranking amps based on?
What is 32 degrees
Do not use this type of wrench to break loose tight fasteners.
What are open end