Personal Protective Equipment
Safe Workplace Operation
Tools and Machinery
Signs and Agencies
Fire Extinguishers
100

The most commonly reported injuries in the automotive industry are:

Eye injuries

100

Which types of fire can plain water be used on?

Type A

100

Defective or unsafe tools should be:

Tagged and reported to the supervisor

100

Responsible for enforcing safety legislation in the workplace

Occupational Safety & Health Administration (OSHA)

100

P in the P.A.S.S. method

Pull the pin

200

What type of gloves is recommended when using moving machinery?

You should not wear gloves when operating moving machinery

200

Safety Data Sheets contain information on PEL. What is PEL?

Permissible Exposure Limit to a chemical

200

Why is the risk of fire and electrocution greater in portable tools than in stationary tools?

Because portable tools are more likely to move into volatile areas

200

Predominantly red signs and indicate an immediate hazard

Warning Signs

200

Number of fire extinguishers are in the auto shop and location.

4, one at both exit doors. one in the tool room and one by the lifts

300

Wearing jewelry while working in the auto shop

May create a physical hazard and may create an electrical hazard

300

Which type of fire extinguisher should be used on flammable liquid fires?

Type B

300

What is a powers machine’s “throw”?

The direct line out from the tool

300

Indicate potentially hazardous situations that could result in serious injury or death

Danger Signs

300

A in the P.A.S.S. method

Aim at the base of the fire

400

When handling chemicals and solvents, technicians are recommended to wear

non-porous nitrile gloves

400

A carbon dioxide fire extinguisher will put out a fire because

Removes oxygen

400

Using a jack at an inappropriate jacking point:

Can cause the vehicle to drop and can puncture fragile points on the underside of the vehicle

400

Predominantly yellow signs and warn of potential dangers

Caution Signs

400

S & S in the P.A.S.S. method

Squeeze the handle and Sweep side to side

500

The most common problems with negative pressure respirators:

Can be corrected by checking filters and valves

500

General ventilation is effective only if:

The hazardous material has low toxicity and flammability levels and there is ample air flow

500

Two precautions to stabilize a lifted vehicle are

Block the wheels opposite the jack and activate the parking brake

500

Governs the safe storage, handling and disposal of chemicals and materials hazardous to the environment

Environmental Protection Agency (EPA)

500

Type C fire

Electrical

M
e
n
u