Fasteners
If you were wanting to remove a screw fastener what tool would you.
Screwdriver
What tool should a technician use to hold piston rings compressed to install piston into the cylinder?
Piston Ring Compression Tool
When setting the rocker arm gap on a valve what tool should a technician use?
Feeler Gauge
Dave needs to borrow a 1/2" deep socket from Sam. Sam said he only has one, it has a small crack in it but he has been using it for years like this. Should Dave use this socket as well since it hasn't given Sam any problems?
NO!!!!
What type of fastener would you be removing with a box end wrench?
Bolt
This tool is used to install and remove piston rings safely.
Piston ring installer & expander
What tool would be best to break the seal of a seal when removing a part that is stuck on an engine with out denting or damaging any parts?
Dead Blow Hammer
What is 1 good practice after using each tool at the end of day?
Clean tool
Store properly
What are the 3 drive sizes of ratches we find most common in our toolboxes?
1/4", 3/8", 1/2"drive
What hand tool is used to measure cylinder pressure?
Compression Tester
A technician is putting new spark plugs in a customers vehicle. He needs to check and set gaps on the spark plugs. His boss Chuck says to use a dial caliper but his buddy Danny that works in the shop as well says to use feeler guages. Who is correct?
Danny
When storing a Torque Wrench what is the most important thing to do to wrench before putting it in toolbox for storage?
Set it to neutral or 0
A technician is wanting to remove the plastic panel to gain access to wiring under a dash in a vehicle, what tool should he get from his tool box?
Trim Tool
This tool is used to safely compress valve springs for installation in the engine head.
Valve Spring Compressor
If a technician was wanting to find the size of a bored hole in an engine block what tool would work best for this?
Dial Caliper or Digital Caliper
What does PPE stand for?
Personal Protective Equipment
This tool is used to set the tension of a fastener to a certain specification.
Torque Wrench
A technician is wanting to fix imperfections on the cylinder walls of an engine before putting new rings on the pistons and installing them in the engine. What tool is used for this?
Cylinder Hone
A technician wants to know what tool he could use to find the length of gas line to cut?
Tape Measure
If a technician is having to cut a bolt of with a cut off wheel what 2 PPE devices should he have on?
Safety Glasses
Safety Shield