Safety & Tools
What class extinguisher is required to put out an electrical fire?
What is class C
To determine the correct tire inflation pressure, we would look at the?
What is the tire placard
This device allows hydraulic fluid flow to the rear braking system first.
What is a metering valve
What is the most common suspension performance test?
What is a jounce test
When a battery is discharged it can off gas this chemical.
What is hydrogen
WorkSafeBC regulations specify that safety glasses meet this standard.
What is CSA Z94.3
A tires section height that is represented by a percentage of the section width is referred to as the?
What is the aspect ratio
My brake pressure created by the master cylinder is 400psi. It is pushing on a caliper piston with a surface area of 4". How much force is my caliper piston outputting?
What is 1600lbs
This suspension geometry design does not utilize an upper ball joint.
What is the MacPherson strut
If I have an electrical circuit with 12 volts and 3 ohms of resistance, what is my current flow?
What is 4A
At this continual noise level, hearing protection should be worn.
What is 85 dB
When tightening a wheel bearing axle nut with an impact gun this damage can occur.
What is brinelling
This device allows a difference in pressure when comparing front to back brake pressure.
What is a proportioning valve
The inward tilt of the imaginary line passing through the upper and lower steering knuckle pivot points when compared to the center line is this.
What is the SAI
A 12-volt battery consists of 6 cells. How many volts are in each cell?
What is 2.1 volts
This tool is most likely to round off a bolt head.
What is a 12-point wrench/socket
When balancing a tire, it is asking for an equal amount of weight on the inboard and outboard rim of the wheel. This tire has what type of imbalance?
What is static imbalance
Dot5 brake fluid cannot be mixed with any other Dot rated brake fluid because it is?
What is a silicone-based fluid
The best way to compensate for road crown is to adjust this angle.
What is caster
When performing high voltage electrical tests, this basic rule should always be followed.
What is the one hand rule
Which tool is used to measure play?
What is a dial indicator
This bearing design is best suited for heavy-duty applications.
What is tapered roller bearing
If my brake pedal sinks to the floor when stopped, what is likely the cause?
What is a failed master cylinder
This alignment angle will not cause the vehicle to pull.
What is toe
When measuring voltage in a circuit, the meter should be connected in this type of circuit.
What is a parallel circuit