HAIR & SCALP TREATMENT
A scalp massage as part of a scalp treatment most often includes ___________ massage moveements.
rotary and sliding
________ is preformed by holding the hair section between your fingers and cutting either from the top to the bottom of the section or from one side to the other.
Finger-and-razor cutting
(__ degrees of elevation)
0
________ is equal or appropriate proportions that create symmetry and harmony in a design
Balance
what is the widest area of the head also known as the crest, hatband, horseshoe, or temporal region?
Parietal ridge
Hair conditioners typically range from ____to_____ on the ph scale.
3.0-5.5
In __________ the angle of the razor blade is increased to almost 90 degrees, producing the least amount of tapering to the hair ends.
Terminal blending
The angle or degree at which a section of hair is held from the head for cutting, relative to where it grows is __________
Elevation
Tapering is the action of of gradually ________ the ________ of the hair with out any lines of demarcation such as gaps or steps.
increasing, length
_________ are also known as attachment combs are made of plastic, hard rubber, or steel for both detachable blade and adjustable blade clippers.
clipper gaurds
which of the following does not help to stimulate muscles, nerves, and blood vessels in the scalp area?
Length of fingers
balls of the finger tips
cushions of the palms
tips of the finger nails
tips of the finger nails
In _________ the razor is held almost flat against the surface of the hair, cutting only a small amount of hair using very little pressure.
Light taper-blending
Hair held straight out from the head from where it grows is _______
90 degrees elevation
_______ guide moves along a section of hair as each cut is made while ________ guide is used for maintaining the length of a section while subsequent partings are brought from other sections to meet it for cutting.
Traveling, Stationary
The most important factors that determine the tools used to achieve the haircut are the _________, the _______, the ________ of the hair and the barbers personal preference.
clients desired outcome, texture, density
what can be used if a scalp steamer is unavailable?
hot towels
When razor cutting fine hair use a _______ strike of the razor with _________ pressure.
Light, Very Light
_______ degrees elevation produces weight, bulk, and maximum length at the perimeter of a design.
0
________ can refer to the degree of elevation at which hair is held for cutting, or the position of the fingers when cutting a section of hair.
Angles
What is preformed after the overall cut has been completed to create special effects such as wispy or spiky strands?
Texturizing
what are the 5 steps for a hair tonic treatment?
1. Apply the hair tonic
2. Massage the scalp
3. Apply scalp steam
4. Massage again
5. comb hair into desired style
The hair must be _________ & _________ for best results and to avoid client discomfort.
Clean, Damp
_____-____ degrees of elevation is used to create layered, tapered, stacked or graduated cuts.
45-90
________ is the process of parting subsections opposite from the elevation or direction at which they were cut to check the precision of cutting lines or blending.
Cross-checking
For shaving the ball of the _______ and the first two fingers are positioned on the ______ side of the shanks with the handle pivoted up to allow the little finger to rest on the ______.
thumb, flat, tang