Measurement
Which is larger 1/16" or 1/8"?
1/8"
Which machine would you use to round over the edges of a cutting board?
Router
What must be worn at all times in the shop?
Safety glasses
Which paper is rougher 220 or 80 grit?
80 grit
Generally speaking, what is the shortest piece of lumber you should send through the jointer or planer?
12"
How many feet is 60"?
5
Which machine is used to make boards thinner in thickness?
Planer
What should you do with long hair when working in the shop?
Tie it up or put it up
What direction should all final sanding be done?
With the grain
What must be functional and in place when you use machines?
safety guards
How many feet and inches is 51"?
four feet three inches
Which machine is used to rip boards?
Table saw
What should you wear to prevent dust from entering your lungs?
A dust mask
Name three things sanding removes.
pencil marks, cuts, saw marks, burn marks, pen marks, dents, rough edges, glue
What must you pass with 100% before you can use each machine?
The safety test over each machine
What is half of 1/2"?
1/4"
Which machine is used to cut curves, arcs, and circles?
Band saw or jig saw
What should be worn around loud machines?
Hearing protection
Which would you apply first, stain or polyurethane?
Stain
What must you do before making any special cuts or modifications on the table saw?
Get instructors permission or help
What's half of 3/4"?
3/8"
Which machine is used to cut different angles, such as 45 degrees?
Miter saw
What is the purpose of the red buttons around the shop?
Kills the power to all machines
Why do you dull or round over sharp edges before applying finish?
Finish applies more evenly or won't pool at the edges as bad
Which direction would move the router to route around the outside of a board?
Counter-clockwise