Construction Drawings General
Basic components of Construction Drawings
Power Tools
Comms/Employability
Rigging
100
Construction drawings are traditionally referred to as what, based on the old school printing method, which is no longer used?
What are Blueprints?
100
When you look at any drawing, the first thing to look at is the ______.
What is the Title Block?
100
What you do before you change a blade on a power saw, or change a bit in a drill, or lead a nail gun.
What is disconnect the power?
100
The definition of jargon.
What is specialized terms, words and phrases used in a particular industry?
100
The name of this knot.
What is a square knot?
200
Today, most prints are created/drawn by _____.
What is (CAD) computer-aided drafting?
200
This is a clear area of approximately half an inch around the edge of the drawing area.
What is a Border?
200
The part of the wood grain that #1 is pointing to.
What is the heart side?
200
What is meant by Active Listening.
What is paying intentional attention to what is being said and how it's being said?
200
The name of this knot.
What is a clove hitch?
300
The place you look within a drawing packet to find out what the symbols and abbreviations mean.
What is the legend?
300
You look at this part of a drawing, located in or near the title block, to make sure you're looking at the most current version of the drawing.
What is the revision block?
300
There are two gauges on an air compressor. The gauge on the left tells you this.
What is "the air pressure inside the tank"?
300
The most important thing to do when giving someone instructions or asking for a tool.
What is "be specific"?
300
The name of this part of a cable sling.
What is a turnback eye?
400
The number of MAJOR types/groups of drawings are almost always included in a set of construction drawings is __________.
What is 6?
400
This line is shown as a thin, dashed line that is used to indicate edges, surfaces or corners that are not visible from the current viewpoint.
What is a hidden line?
400
What you do before you connect any pneumatic tool to the air compressor.
What is check the recommended air pressure for the tool?
400
The best time and place to give assembly instructions to your crew.
What is ."in a quiet place when they are fresh and not too tired"?
400
The name of this piece if hanging hardware.
What is a "shackle"?
500
The elevation base point that a surveyor uses when they survey a construction site. All other property elevation points are referenced from this.
What is the benchmark?
500
This is the measuring system that is used to indicate size and distance on drawings that translates to real world measurements.
What is scale?
500
The type of cut you never do on a compound miter saw.
What is a rip cut?
500
The best way to let your crew know where to go for the next location you'll be working at, as you all get into your vehicles to drive there.
What is "send a text message"?
500
What part of this Crosby clamp is the line pointing to?
What is the saddle?