Tools
Plumbing
Carpentry
Electric
Chance
100
When using a circular saw, the blade should extend this below the surface of the workpiece
What is 1/4" or the depth of one tooth
100
If you are swaging, what would you be doing?
What is forming a bell end in copper tubing
100
When assembling walls, you should use this size nail
What is a 16 sinker
100
The amount of insulation that should be stripped from a wire
What is 5/8" - 3/4"
100
The tool you would use to smooth a piece of lumber after running it through the planer
What is a belt sander
200
This tool is for tight places, and some of them have low speed and high torque
What is a right angle drill
200
The commonly used trade name for soldering
What is sweating
200
The true dimensions of a 2X4
What is 1 1/2" X 3 1/2"
200
The difference between a single gang and double gang box
What is a single gang box will hold 1 device, a double gang box will hold 2 devices
200
In the "electrical world," green always means???????
What is ground
300
By using this tool, you can figure out what angle or pitch is cut on a board
What is a speed square
300
The name of the material use to help solder flow into the fitting
What is flux
300
An 8 penny nail is approximately this long
What is 2 3/8"
300
How close to a plastic box does roamex have to be stapled
What is within 8"
300
Roamex is a generic trade name for?????
What is non metallic sheathed cable
400
This tool is used to let you know that voltage is present, but does not tell you how much voltage is there
What is a tic tester or non contact voltage tester
400
The fitting you would use above equipment such as a hot water tank, for easy removal and replacement
What is a union
400
When framing a rough opening for a 32" window, the rough opening should be approximately
What is 32 3/4"
400
How do you determine the distance that a box should stick out beyond the face of a wall stud
What is it should stick out the same amount as the thickness of the wall finish material
400
How much wood would a wood chuck chuck if a wood chuck could chuck wood?
What is a wood chuck would chuck all the wood he would chuck if a wood chuck could chuck wood
500
This tool is used to form edges on wood, plow dados, and various other procedures
What is a router
500
This fitting is typically found behind a shower wall (the shower arm threads into it) and it has a tab on both sides with holes in them
What is a drop eared ell
500
Keeping in mind all the framing components that make up the total height of a wall, how tall would a wall be if the studs were cut 84" long?
What is 88 1/2" or 7' 4 1/2"
500
Why must you be careful to not nick the conductor while stripping insulation
What is it will reduce the current carrying capacity of the conductor
500
Explain how and where the wires terminate when installing a single pole switch.
What is the ground wires are twisted with a pigtail, wire nutted, and hooked to the ground screw, the neutrals twist and wire nut together, and the blacks go to the gold terminals
M
e
n
u