G-Codes
Commands Rapid Motion Positioning
What is G00?
Commands a Tool Change
What is M06?
The Letter "T"
What is Tool Selection?
Peck Drill Canned Cycle
What is G83?
This button immediately stops all machine motion
What is the E-Stop?
There is no place like "HOME"
What is G28?
Commands coolant on
What is M08?
The Letter "S"
What is Spindle RPM?
Drill Canned Cycle
What is G81?
This coordinate system is set by the operator to define part zero
What is a Work Coordinate System?
Commands Absolute Positioning
What is G90?
Commands spindle on clockwise
What is M03?
The Letter "F"
What is Feed Rate?
Spot Drill Canned Cycle
What is G82?
This is the sound you don’t want to hear when machining.
What is chatter, or BOOM?
Commands Clockwise Circular Interpolation
What is G02?
Commands spindle to stop
What is M05?
The Letter "H"
What is Tool Length Offset Value?
Tapping Canned Cycle
What is G84?
This happens if you call T01 but use H02 in your program
What is a Potential Crash?
Commands Tool Length Compensation +
What is G43?
Commands program end and reset
What is M30?
The Letter "O"
What is the Program Number?
Canned Cycle Cancel
What is G80?
G00 G17 G40 G49 G80 G90
What is a Safety Line?